Philips EPIA-MII user manual CD Audio Connector Cdin, Front Audio Panel Faudio

Page 31

Chapter 2

CD Audio Connector: CD_IN

This connector is for the CD-ROM audio connector.

CD_IN

CLE266

Front Audio Panel: F_AUDIO

This connector allows you to connect a front audio panel to the mainboard. Only the line-out and microphone functions are available for use on the front panel. To connect the front audio cable, first remove the two red plastic

jumpers.

Pin	Signal	Pin	Signal
1	FRN_MIC	2	AGND
3	AUD_MIC_BIAS	4	+5V
5	LINE_OUT_R	6	NEXT_R
7	NC	8	Blank
9	LINE_OUT_L	10	NEXT_L
	2		10
	1		9
		F_AUDIO

CLE266

2-16

Image 31

Contents User’s Manual Trademarks CopyrightDisclaimer FCC-B Radio Frequency Interference Statement Safety Instructions Box Contents Page Table of Contents Chapter Mainboard Specifications Back Panel I/O Ports Onboard I/O ConnectorsForm Factor Back Panel Mainboard LayoutAdd-On Module Placement of Add-On ModuleSlots Back Panel PortsConnecter/Jumper Description Onboard Connectors and JumpersChapter Installation VIA C3TM E-Series Processor CPUVIA Eden Processor DDR Sdram Module Installation Procedures Memory Module InstallationAvailable DDR Sdram Configurations ATX 20-Pin Power Connector Connecting the Power SupplyKeyboard Port PS2KB Mouse Port PS2MSVideo Port VGA OutUSB Ports RJ45 10/100 NIC PortSerial Port COM1 Ieee 1394 PortCard Slots PCMCIA, CF Audio Jacks Line-In, Line-Out, Microphone IDE2 Secondary IDE Connector ConnectorsHard Disk Connectors IDE1 & IDE2 IDE1 Primary IDE ConnectorPower LED PWR LED Case Connector FpanelSpeaker Consumer Infrared Module / PS2 Header Kbms IrDA Infrared Module Connector FIRWake-on LAN WOL USB pin-header USB3/4COM2 The Second Serial Port Floppy Disk Drive Connector FDDFront Audio Panel Faudio CD Audio Connector CdinLPT Pin Header LPT SMBus Connector SMBusLvds Connector Optional Port ConnectorClear Cmos Clearcmos JumpersRCA Video or S/PDIF Select Spdifsel PCI Interrupt Request Routing Peripheral Component Interconnect PCIBios Setup Control Keys Entering SetupGeneral Help F1 Getting HelpMain Menu Sub-MenuMain Menu Set User Password Load Fail-Safe DefaultsLoad Optimized Defaults Set Supervisor PasswordDrive A/B Standard Cmos FeaturesDate TimeIDE Primary Master/Slave, Secondary Master/Slave CPU L2 Cache ECC Checking Advanced Bios FeaturesQuick Power On Self Test Virus WarningSwap Floppy Drive First/Second/Third Boot DeviceBoot Other Device Boot Up Floppy SeekTypematic Rate Chars/Sec Boot Up NumLock StatusTypematic Rate Setting Typematic Delay MsecDisplay Small Logo Show Summary InformationAGP Mode Internal Advanced Chipset FeaturesAGP Aperture Size Select Display Device CPU Direct Access FBAGP Fast Write CPU to PCI Post WriteDisplay Card Priority IDE Prefetch ModeIntegrated Peripherals Onboard IDE Channel 1/2OnChip USB Controller Onboard Lan Boot ROMAC97 Audio VIA OnChip LANOnboard Serial Port 1/2 Parallel Port ModeSuperIO Device Onboard FDC ControllerFast IR IRQ EPP Mode SelectECP Mode Use DMA Onboard Fast IRHDD Power Down Power Management SetupAcpi Suspend Type Video Off Option Power Management TimerPower Off by Pwrbtn Run Vgabios if S3 ResumePeripheral Activities PS2MS Wakeup from S3/S4/S5 PowerOn by PCI CardWake On LAN/Ring Connector RTC Alarm ResumePrimary Intr IRQs ActivitiesResource Controlled By PNP/PCI ConfigurationsPNP OS Installed Reset Configuration DataAssign IRQ For VGA/USB IRQ Resources PC Health Status Dram CAS Latency Frequency / Voltage ControlDram Clock Dram TimingActive to Precharge Tras Dram Command RateBank Interleave Precharge to Active TrpCPU Clock Dram VoltageSpread Spectrum Load Fail-Safe Defaults Load Optimized Defaults Set Supervisor / User Password Bios Setup Save & Exit Setup Exit Without Saving Chapter Driver Installation Getting Started Driver UtilitiesRunning the Driver Utilities CD CD Content Chapter