Fujitsu MB88121 SERIES, MB91460 SERIES manual Use Active configuration Standalone

SK-91F467-FLEXRAY V1.1

Getting Started

Start Softune Monitor Debugger via the “Debug” Command

Figure 5-6: Start Softune Workbench Monitor Debugger

10.After the project is built and debugged successfully switch to the active configuration

STANDALONE

5.2.3Use Active configuration STANDALONE

11.With this selection the project is linked to work in internal flash memory. This configuration will not work with the Softune Workbench monitor debugger. In this configuration the code is linked to work in internal Flash memory, only.

12.Use “Make”, or “Build” to compile and link the project for internal Flash memory. The generated output files can be found in the sub-folder STANDALONE of the project folder. The *.mhx file (Motorola S-Record) is located in the ABS sub-folder.

Note:

Always check the memory map of the linker settings and ensure that this memory map is suitable for the application and target system in use. Additionally the *.mp1 file should be checked to ensure correct settings.

13.Program the generated *.mhx file (Motorola S-Record) with the Flash programming utility into the internal Flash. See Chapter 6.1 “Programming the internal Flash Memory” for more details.

© Fujitsu Microelectronics Europe GmbH - 51 - FMEMCU-UG-910017-11