Atlantis Land A02-RA(Atmos)_ME01 channel info, channel interface, channel lcpmaxconfigure, Syntax

Learning occurs in this direction only.

Setting hdlc to 0 clears this learned state. Configuration saving does not save the learned state.

8.11<channel> info

8.11.1Syntax

<channel> info [all]

8.11.2 Description

Provide information about the current settings of this channel. This includes all configured state, and also current protocol information.

Specifying all prints out more information. info and status are synonyms.

8.12<channel> interface

8.12.1Syntax

<channel> interface <n>

8.12.2 Description

Logically associate the specified channel with the specified interface.

Interface 1 is always the router port. It should be used for any PPP channel over which IPCP communication with the local system’s IP router is desired. Other interfaces can be created for bridging. A single PPP channel can only be associated with a single interface, or a single tunnel.

Use info to find the current setting.

Calling with n=0 removes any association. This is the default state. Configuration saving saves this information.

8.13<channel> lcpmaxconfigure

8.13.1Syntax

<channel> lcpmaxconfigure [<n>]

8.13.2 Description

Set the Max-Configureparameter for LCP, as described in Section 4.6 of RFC1661. This is the maximum number of Configure Requests that will be sent without reply, before assuming that the peer is unable to respond.

Call with no argument to find the current setting. The default value is 10.

Configuration saving saves this information.

8.14 <channel> lcpmaxfailure