Atlantis Land A02-RA(Atmos)_ME01 manual arprouting, autoloop, Syntax, Description, Example

arp	add	ether	192.168.50.1	08:00:20:19:9a:d9 # forever
arp	add	ether	192.168.50.57	00:20:af:2e:fa:3c # 3m13s

mymachine> ip arp flush

mymachine> ip arp

#flane ARP table is empty

#ether ARP table is empty mymachine> ip arp

arp add	flane	192.168.2.108 00:20:2b:03:0a:72 # 10m58s
# ether	ARP table is empty

(The last example shows that the MAC address for 192.168.2.108 has been automatically added again, having been discovered by means of the ARP protocol.)

10.4arprouting

10.4.1Syntax

arprouting [on]off [<i/f>]

10.4.2 Description

The arprouting command was intended to control whether a router would perform proxy ARP on an Ethernet-like interface; that is, reply with its own MAC address to an ARP request for any IP address that it would route to. However, it is not supported and is believed currently (ATMOS IP version 1.29) not to work correctly; the command is hidden, not shown by ip help.

10.5autoloop

10.5.1Syntax

autoloop [onoff]

10.5.2 Description

Displays or sets the autoloop setting. This has effect only when a loopback device is configured (see device on page 162): in that case, it controls whether datagrams addressed to the machine’s own IP addresses (and not just the loopback addresses 127.*.*.*) will be looped back.

Configuration saving saves this information. By default, autoloop is disabled. The autoloop command is hidden, not shown by ip help.

10.5.3 Example

mymachine> ip autoloop

autoloop off

mymachine> ip device

# type dev file IP address