ppp 2 remoteip 192.168.200.2
ppp 2 enable
(and the corresponding setup for each of the channels 3 to 8 as well)
Clients can now dial in to this server, be allocated IP addresses and traffic will be sent to and from the router.
8.2.4 Remote Bridging
To create a system where two bridges are connected by a PVC, do the following at each end: (In this example, interface 2 is attached to the bridge in ATMOS (interface 1 is reserved for routed traffic).)
bridge device add ppp/DEVICE=2
(Attach interface 2 to the bridge.)
ppp1 pvc 32 mac ppp 1 interface 2
ppp 1 enable
If required, multiple interfaces can be attached to the bridge of a single ATMOS system so that a single master site is bridged to several satellites. Each incoming bridging PPP channel should be attached to a distinct interface. Each interface must be independently attached to the bridge.
8.3 <channel> clear
8.3.1 Syntax
<channel> clear
8.3.2 Description
Clear all aspects of this channel back to their default settings. If there is an active connection, it is torn down.
8.4 <channel> disable
8.4.1 Syntax
<channel> disable
8.4.2 Description
Clear the enable flag for a PPP channel. This is the default setting. Disabling does not remove other configured information about this channel.
In the PPP state machine, this sets the PPP link to closed. If it is already closed, there is no effect.
Configuration saving saves this information. By default, all channels are disabled.
