Atlantis Land A02-RA(Atmos)_ME01 manual channel lcpmaxterminate, channel llc, Syntax, Description

8.14.1 Syntax

<channel> lcpmaxfailure [<n>]

8.14.2 Description

Set the Max-Failureparameter for LCP, as described in Section 4.6 of RFC1661. This is the maximum number of consecutive Configure Naks that will be sent before assuming that parameter negotiation is not converging.

Call with no argument to find the current setting. The default value is 5.

Configuration saving saves this information.

8.15<channel> lcpmaxterminate

8.15.1Syntax

<channel> lcpmaxterminate [<n>]

8.15.2 Description

Set the Max-Terminateparameter for LCP, as described in Section 4.6 of RFC1661. This is the maximum number of Terminate Requests that will be sent without reply, before assuming that the peer is unable to respond.

Call with no argument to find the current setting. The default value is 2.

Configuration saving saves this information.

8.16<channel> llc

8.16.1Syntax

<channel> llc [10]

8.16.2 Description

If 1, use an LLC header on the front of transmitted packets and require one on received ones. This consists of four bytes, FE-FE-03-CF, and is required for PPP Over AAL5 (RFC 2364 p4) when using LLC encapsulated PPP. If 0, disable this.

Call with no argument to find the current setting. The default value is 0 (disabled).

Configuration saving saves this information.

If not set, and a packet is received with an LLC header, the channel goes into a learned LLC mode and sends packets with the LLC header. Thus, interoperation with LLC-using equipment should not normally require any configuration. Learning occurs in this direction only. Setting hdlc to 0 clears this learned state. Configuration saving does not save the learned state.