Xerox KS-801 operation manual

Page 20

The following figure illustrates an example of 2-port trunk connection between switch A and switch B. The aggregated bandwidth of the trunk is 400Mbps.

Rules :

1.One switch can be configured to have up to 2 trunks and each trunk is composed of 2 trunking ports.

2.One trunking port can only belong to one trunk.

3.Only one trunk can exist between two switch units.

4.Crossover UTP cables should be used at the same time for one trunk connection. The length of each cable can be up to 100 meters.

5.When the switched data ports are enabled as trunking ports, they can only serve trunking function, but no other data function.

6.Since the trunking is proprietary, the switches do not support trunk connection to other brand switches.

-20-

Image 20

Contents 10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Console & Telnet Management Web ManagementIntroduction Features Page Specifications Installing the Switch Packing ListPanels Mounting the Switches Install Rack Mount BracketsInstall the Switch into a 19-inch Rack Desktop MountingNetwork Switched Ports Making Network Connections10/100BASE-TX Fast Ethernet Switched Ports MDI-X and MDI RJ-45 ConnectorsManual Configuration 10/100BASE-TX Fast Ethernet PortsAuto-negotiation Capable Auto-speed-sensingStraight-through and Crossover UTP Cable Flow ControlUTP Cable Connections Module Connector type Fiber cable Maximum length Fast Ethernet Fiber SlotFiber Module Top view Fiber Jumper Setting Module OutlineModule Installation Duplex Mode SettingSpecifications Switch supports the following trunk configurations Making Trunk ConnectionsPage When doing sniffer, configure Making SnifferMonitored Ports Sniffer PortInterpretation LED IndicatorsLED Panels Performing Network Management Management SupportLogin Port Status Management objectsSetting IP Address Console ManagementRefer to for more information Telnet ManagementConsole port does not support modem connection Snmp Management SupportConsole & Telnet Management Set IP Address IP StatusSelect 1 from main menu to set IP address Select 2 from main menu to view IP statusView Port Status Port status definitions areView Port Counters View STP Status Page Restore Default Values Update Firmware Console Sftp UtilityPrompts shown on DOS screen are as follows \WINDOWSSFTPRemote Boot System Processing messages shown on console screen areSet IP Address for the Switch Web ManagementStart Browser Software and Making Connection Web BrowserFactory default Username Admin Factory default Password Login to the SwitchLogin Page Port Status Port Statistics Administrator Click Basic to view or modify the following settings BasicIP Address settings are IP AddressUse scroll bar to view all settings as follows Snmp EntriesSnmp settings are Advanced Click Advanced in menu to performAdvanced / Spanning Page Page Priority is assigned to the switch. The higher MAC address of the switch as a unique identiValue is lower priority. Range 0 Fier to the networkPorts which are enabled can be in one of the follow Listening Switches send messages to one anotherBlocking The switch enters the Blocking State if a Learning The switch enters the Learning State if noAdvanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager System Manager Click System Manager to performTftp Update Firmware Click Apply to start Tftp file transfer operationsPage Remote Boot System