Xerox KS-801 operation manual

Page 33

StpStatus Ports which are enabled can be in one of the follow- ing states:

Listening : Switches send messages to one another to establish the network topology and the optimal paths to the different segments of the network. Other data is not transmitted.

Blocking : The switch enters the Blocking State if a path with higher priority is found to exist during the Listening State. Normal data is not transmitted.

Learning : The switch enters the Learning State if no path with a higher priority is found during the Listening State. Learned entries are entered in the Unicast Destination Forwarding Table. Normal data is not transmitted.

Forwarding : The switch enters the Forwarding State after having been in the Learning State for a pre- defined time period. Normal data is transmitted.

This menu only supports to view STP settings and status. To change STP settings, use Web management method via browser software. Refer to Web Management Operation manual of the switch for more details.

-33-

Page 32 Page 34
Image 33
Page 32 Page 34
Contents 10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Web Management Console & Telnet ManagementIntroduction Features Page Specifications Packing List Installing the SwitchPanels Install Rack Mount Brackets Mounting the SwitchesInstall the Switch into a 19-inch Rack Desktop MountingMaking Network Connections Network Switched PortsMDI-X and MDI RJ-45 Connectors 10/100BASE-TX Fast Ethernet Switched Ports10/100BASE-TX Fast Ethernet Ports Manual ConfigurationAuto-negotiation Capable Auto-speed-sensingFlow Control UTP Cable ConnectionsStraight-through and Crossover UTP Cable Fast Ethernet Fiber Slot Module Connector type Fiber cable Maximum lengthModule Outline Fiber Module Top view Fiber Jumper SettingDuplex Mode Setting SpecificationsModule Installation Making Trunk Connections Switch supports the following trunk configurationsPage Making Sniffer When doing sniffer, configureMonitored Ports Sniffer PortLED Indicators LED PanelsInterpretation Management Support Performing Network ManagementManagement objects Login Port StatusConsole Management Setting IP AddressTelnet Management Console port does not support modem connectionRefer to for more information Support Snmp ManagementConsole & Telnet Management IP Status Set IP AddressSelect 1 from main menu to set IP address Select 2 from main menu to view IP statusPort status definitions are View Port StatusView Port Counters View STP Status Page Restore Default Values Console Sftp Utility Update Firmware\WINDOWSSFTP Prompts shown on DOS screen are as followsProcessing messages shown on console screen are Remote Boot SystemWeb Management Set IP Address for the SwitchStart Browser Software and Making Connection Web BrowserLogin to the Switch LoginFactory default Username Admin Factory default Password Page Port Status Port Statistics Administrator Basic Click Basic to view or modify the following settingsIP Address IP Address settings areSnmp Entries Use scroll bar to view all settings as followsSnmp settings are Click Advanced in menu to perform AdvancedAdvanced / Spanning Page Page MAC address of the switch as a unique identi Priority is assigned to the switch. The higherValue is lower priority. Range 0 Fier to the networkListening Switches send messages to one another Ports which are enabled can be in one of the followBlocking The switch enters the Blocking State if a Learning The switch enters the Learning State if noAdvanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager Click System Manager to perform System ManagerClick Apply to start Tftp file transfer operations Tftp Update FirmwarePage Remote Boot System
Top Page Image Contents