Xerox KS-801 operation manual Snmp Management, Support

Page 27

5.7 SNMP Management

SNMP management are performed at a network management station run- ning SNMP network management application manager software with graphical user interface.

The switch serves as an SNMP agent and provides the capabilities that allows network administrators to set parameters and view statistical counters defined in the standard MIB-II and private MIB.

The supported MIBs are available in the supplied CD-ROM of the switch. Use the SNMP management application software to compile the MIB file first before performing any management operation.

5.8 Support

This guide covers the basic information about the management func- tions supported by the managed switch. However, more features may be included into future new software upgrade. Contact the dealer where you purchased the switch for the availability of new software and/or techni- cal support.

-27-

Image 27

Contents 10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Web Management Console & Telnet ManagementIntroduction Features Page Specifications Packing List Installing the SwitchPanels Desktop Mounting Mounting the SwitchesInstall Rack Mount Brackets Install the Switch into a 19-inch RackMaking Network Connections Network Switched PortsMDI-X and MDI RJ-45 Connectors 10/100BASE-TX Fast Ethernet Switched PortsAuto-speed-sensing Manual Configuration10/100BASE-TX Fast Ethernet Ports Auto-negotiation CapableFlow Control UTP Cable ConnectionsStraight-through and Crossover UTP Cable Fast Ethernet Fiber Slot Module Connector type Fiber cable Maximum lengthModule Outline Fiber Module Top view Fiber Jumper SettingDuplex Mode Setting SpecificationsModule Installation Making Trunk Connections Switch supports the following trunk configurationsPage Sniffer Port When doing sniffer, configureMaking Sniffer Monitored PortsLED Indicators LED PanelsInterpretation Management Support Performing Network ManagementManagement objects Login Port StatusConsole Management Setting IP AddressTelnet Management Console port does not support modem connectionRefer to for more information Support Snmp ManagementConsole & Telnet Management Select 2 from main menu to view IP status Set IP AddressIP Status Select 1 from main menu to set IP addressPort status definitions are View Port StatusView Port Counters View STP Status Page Restore Default Values Console Sftp Utility Update Firmware\WINDOWSSFTP Prompts shown on DOS screen are as followsProcessing messages shown on console screen are Remote Boot SystemWeb Browser Set IP Address for the SwitchWeb Management Start Browser Software and Making ConnectionLogin to the Switch LoginFactory default Username Admin Factory default Password Page Port Status Port Statistics Administrator Basic Click Basic to view or modify the following settingsIP Address IP Address settings areSnmp Entries Use scroll bar to view all settings as followsSnmp settings are Click Advanced in menu to perform AdvancedAdvanced / Spanning Page Page Fier to the network Priority is assigned to the switch. The higherMAC address of the switch as a unique identi Value is lower priority. Range 0Learning The switch enters the Learning State if no Ports which are enabled can be in one of the followListening Switches send messages to one another Blocking The switch enters the Blocking State if aAdvanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager Click System Manager to perform System ManagerClick Apply to start Tftp file transfer operations Tftp Update FirmwarePage Remote Boot System