Xerox KS-801 operation manual Restore Default Values

Page 34

6.6 Restore Default Values

Select [6] from main menu to restore factory default settings.

Factory default settings are:

IP Address				192.168.0.5
Subnet Mask				255.255.255.0
Default		Gateway		192.168.0.254
Spanning		tree		Disabled
Trunking				Disabled
Sniffering				Disabled
Port	Control			Enabled
Speed				Auto
Duplex				Auto
Flow	Control			Enabled
User	Name			admin
Password				123
RS232	Baud			38400
RS232	Data		bit	8
RS232	Parity			none
RS232	stop		bit	1
RS232	flow		control	none

-34-

Image 34

Contents 10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Console & Telnet Management Web ManagementIntroduction Features Page Specifications Installing the Switch Packing ListPanels Install the Switch into a 19-inch Rack Mounting the SwitchesInstall Rack Mount Brackets Desktop MountingNetwork Switched Ports Making Network Connections10/100BASE-TX Fast Ethernet Switched Ports MDI-X and MDI RJ-45 ConnectorsAuto-negotiation Capable Manual Configuration10/100BASE-TX Fast Ethernet Ports Auto-speed-sensingUTP Cable Connections Flow ControlStraight-through and Crossover UTP Cable Module Connector type Fiber cable Maximum length Fast Ethernet Fiber SlotFiber Module Top view Fiber Jumper Setting Module OutlineSpecifications Duplex Mode SettingModule Installation Switch supports the following trunk configurations Making Trunk ConnectionsPage Monitored Ports When doing sniffer, configureMaking Sniffer Sniffer PortLED Panels LED IndicatorsInterpretation Performing Network Management Management SupportLogin Port Status Management objectsSetting IP Address Console ManagementConsole port does not support modem connection Telnet ManagementRefer to for more information Snmp Management SupportConsole & Telnet Management Select 1 from main menu to set IP address Set IP AddressIP Status Select 2 from main menu to view IP statusView Port Status Port status definitions areView Port Counters View STP Status Page Restore Default Values Update Firmware Console Sftp UtilityPrompts shown on DOS screen are as follows \WINDOWSSFTPRemote Boot System Processing messages shown on console screen areStart Browser Software and Making Connection Set IP Address for the SwitchWeb Management Web BrowserLogin Login to the SwitchFactory default Username Admin Factory default Password Page Port Status Port Statistics Administrator Click Basic to view or modify the following settings BasicIP Address settings are IP AddressUse scroll bar to view all settings as follows Snmp EntriesSnmp settings are Advanced Click Advanced in menu to performAdvanced / Spanning Page Page Value is lower priority. Range 0 Priority is assigned to the switch. The higherMAC address of the switch as a unique identi Fier to the networkBlocking The switch enters the Blocking State if a Ports which are enabled can be in one of the followListening Switches send messages to one another Learning The switch enters the Learning State if noAdvanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager System Manager Click System Manager to performTftp Update Firmware Click Apply to start Tftp file transfer operationsPage Remote Boot System