Xerox KS-801 operation manual Prompts shown on DOS screen are as follows, Windowssftp

Page 36

The steps are:

1.Connect your PC to the switch console port via PC COM port.

2.Start the console management and select Update Firmware com- mand.

---------------------------------------------

Waiting for program Download for EPROM ......

---------------------------------------------

This message indicates the switch is ready to receive file from console port.

3.Execute the utility program SFTP.EXE from your DOS window. The command syntax is:

C:\WINDOWS>SFTP n filename <Enter> n: 1=COM1 2=COM2

filename: the file name of the new firmware

The prompts shown on DOS screen are as follows:

---------------------------------------------

C:\WINDOWS>SFTP

1

image.bin

 

+

----------------------------------------------

 

 

 

+

Down

Load

Program

..........

Usage: sftp

1[/2]

<filename>

(Default:

COM1,38400,8

Data, 1 Stop,

NoParity)

+

----------------------------------------------

 

 

 

+

$Inputfile

name

:

image.bin

 

$Need to change communication parameters?[Y/n]n

Transferring image.bin (xxx bytes) to ....

.....

Data Transfer Finished.

C:\WINDOWS>

---------------------------------------------

-36-

Page 35 Page 37
Image 36
Page 35 Page 37
Contents 10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Console & Telnet Management Web ManagementIntroduction Features Page Specifications Installing the Switch Packing ListPanels Mounting the Switches Install Rack Mount BracketsInstall the Switch into a 19-inch Rack Desktop MountingNetwork Switched Ports Making Network Connections10/100BASE-TX Fast Ethernet Switched Ports MDI-X and MDI RJ-45 ConnectorsManual Configuration 10/100BASE-TX Fast Ethernet PortsAuto-negotiation Capable Auto-speed-sensingFlow Control UTP Cable ConnectionsStraight-through and Crossover UTP Cable Module Connector type Fiber cable Maximum length Fast Ethernet Fiber SlotFiber Module Top view Fiber Jumper Setting Module OutlineDuplex Mode Setting SpecificationsModule Installation Switch supports the following trunk configurations Making Trunk ConnectionsPage When doing sniffer, configure Making SnifferMonitored Ports Sniffer PortLED Indicators LED PanelsInterpretation Performing Network Management Management SupportLogin Port Status Management objectsSetting IP Address Console ManagementTelnet Management Console port does not support modem connectionRefer to for more information Snmp Management SupportConsole & Telnet Management Set IP Address IP StatusSelect 1 from main menu to set IP address Select 2 from main menu to view IP statusView Port Status Port status definitions areView Port Counters View STP Status Page Restore Default Values Update Firmware Console Sftp UtilityPrompts shown on DOS screen are as follows \WINDOWSSFTPRemote Boot System Processing messages shown on console screen areSet IP Address for the Switch Web ManagementStart Browser Software and Making Connection Web BrowserLogin to the Switch LoginFactory default Username Admin Factory default Password Page Port Status Port Statistics Administrator Click Basic to view or modify the following settings BasicIP Address settings are IP AddressUse scroll bar to view all settings as follows Snmp EntriesSnmp settings are Advanced Click Advanced in menu to performAdvanced / Spanning Page Page Priority is assigned to the switch. The higher MAC address of the switch as a unique identiValue is lower priority. Range 0 Fier to the networkPorts which are enabled can be in one of the follow Listening Switches send messages to one anotherBlocking The switch enters the Blocking State if a Learning The switch enters the Learning State if noAdvanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager System Manager Click System Manager to performTftp Update Firmware Click Apply to start Tftp file transfer operationsPage Remote Boot System
Top Page Image Contents