Xerox KS-801 Fast Ethernet Fiber Slot, Module Connector type Fiber cable Maximum length

Page 16

3.3 Fast Ethernet Fiber Slot

The switch provides one fast Ethernet fiber slot. It can accommodate one optional fiber module for your fiber connection. Depending on the fiber interface and the types of fiber cables, the following fiber modules are available for selection:

Module	Connector type	Fiber cable	Maximum length
800-T	ST	MM*	2	Km
800-C	SC	MM	2	Km
800-SA	SC	SM *	15	Km
800-S3	SC	SM	30	Km
800-S5	SC	SM	50	Km
800-JM	MT-RJ	MM	2	Km
800-JS	MT-RJ	SM	15	Km
800-VM	VF-45	MM	2	Km

*MM : Multimode fiber cable, SM : Single mode fiber cable

Switched port #9 supports two types of connections. One type is UTP connection through Port 9X. The other is fiber connection through slot FIBER respectively. Both types of connections can not be used at the same time. Each fiber module provides optional jumpers to enable or disable fiber connection.

-16-

Image 16

Contents 10/100 Fast Ethernet Managed Switch with Fiber Connectivity Trademarks Table of Contents Console & Telnet Management Web ManagementIntroduction Features Page Specifications Installing the Switch Packing ListPanels Mounting the Switches Install Rack Mount BracketsInstall the Switch into a 19-inch Rack Desktop MountingNetwork Switched Ports Making Network Connections10/100BASE-TX Fast Ethernet Switched Ports MDI-X and MDI RJ-45 ConnectorsManual Configuration 10/100BASE-TX Fast Ethernet PortsAuto-negotiation Capable Auto-speed-sensingUTP Cable Connections Flow ControlStraight-through and Crossover UTP Cable Module Connector type Fiber cable Maximum length Fast Ethernet Fiber SlotFiber Module Top view Fiber Jumper Setting Module OutlineSpecifications Duplex Mode SettingModule Installation Switch supports the following trunk configurations Making Trunk ConnectionsPage When doing sniffer, configure Making SnifferMonitored Ports Sniffer PortLED Panels LED IndicatorsInterpretation Performing Network Management Management SupportLogin Port Status Management objectsSetting IP Address Console ManagementConsole port does not support modem connection Telnet ManagementRefer to for more information Snmp Management SupportConsole & Telnet Management Set IP Address IP StatusSelect 1 from main menu to set IP address Select 2 from main menu to view IP statusView Port Status Port status definitions areView Port Counters View STP Status Page Restore Default Values Update Firmware Console Sftp UtilityPrompts shown on DOS screen are as follows \WINDOWSSFTPRemote Boot System Processing messages shown on console screen areSet IP Address for the Switch Web ManagementStart Browser Software and Making Connection Web BrowserLogin Login to the SwitchFactory default Username Admin Factory default Password Page Port Status Port Statistics Administrator Click Basic to view or modify the following settings BasicIP Address settings are IP AddressUse scroll bar to view all settings as follows Snmp EntriesSnmp settings are Advanced Click Advanced in menu to performAdvanced / Spanning Page Page Priority is assigned to the switch. The higher MAC address of the switch as a unique identiValue is lower priority. Range 0 Fier to the networkPorts which are enabled can be in one of the follow Listening Switches send messages to one anotherBlocking The switch enters the Blocking State if a Learning The switch enters the Learning State if noAdvanced / Trunking Advanced / Sniffer Page Console Port Information Port Controls Security Manager System Manager Click System Manager to performTftp Update Firmware Click Apply to start Tftp file transfer operationsPage Remote Boot System