Canon MF8080Cw, MF8380Cdw manual Make sure the WiFi indicator blinks

Page 18

Configuring with WPS Features (Pin Code Mode)

 

 

 

 

 

 

<< Previous

Next >>

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

8. Make sure the WiFi indicator blinks.

When the wireless LAN router or access point is detected, the Wi-Fi indicator blinks.

The screen below is displayed for approximately 2 seconds, and then the Wi-Fi indicator will remain solidly lit.

*If an error message appears, press [OK] to close the screen and follow the procedure again from Step 5

18

Image 18 Canon MF8080Cw, MF8380Cdw manual Make sure the WiFi indicator blinks
Contents ImageCLASS MF8080Cw/MF8380Cdw Previous Next Previous Next Before adding the machine to a wireless LAN Precautions when connecting to a wireless LANSwitching the connection Method to Wireless LAN Select Network Settings with and , and then press OKPress Menu Switching the connection Method to Wireless LAN Turn the machine OFF/ON when the following screen disappears Selecting a method for connecting to the wireless LAN Configuring with WPS Features Recommended MethodConfiguring Manually Configuring with WPS Features YESConfiguring with WPS Features Push Button Mode Select Wireless LAN Settings using or , and then press OKPress OK Configuring with WPS Features Push Button ModeMake sure the WiFi indicator blinks Automatic obtaining of the IP address Auto IP Configuring with WPS Features Pin Code Mode Previous Configuring with WPS Features Pin Code Mode Configuring with WPS Features Pin Code Mode Make sure the WiFi indicator blinks Automatic obtaining of the IP address Auto IP Configuring Manually Select Access PointPreparing Type of Encryption Only when Manually Entering Ssid Configuring Manually Required InformationAccess Point Name/Network Name Network KeyConfiguring Manually Using the Wireless Setup AssistantCheck your network environment Click Additional Software Programs Click Start for Canon MF/LBP Wireless Setup Assistant Write down the information outlined in orange If multiple access points are displayed Configuring Manually Selecting Access Points Press Menu Select Network Settings using or and press OKConfiguring Manually Selecting Access Points Select Select Access Point using or and press OK Configuring Manually Selecting Access Points Either of the following screens is displayed Enter the network key that you have written down Ascii textSelect Yes using and press OK Make sure the Wi-Fi indicator blinks Automatic obtaining of the IP address Auto IP Configuring Manually Manually Entering Ssid Configuring Manually Manually Entering Ssid When the type of encryption is WEP When the type of encryption is WPA/WPA2-PSK Either of the following screens is displayed Enter the network key that you have written down earlier Select Yes using , and then press OK Make sure the Wi-Fi indicator blinks Automatic obtaining of the IP address Auto IP Congratulations
Related manuals
Manual 5 pages 43.82 Kb