adjust certain video settings yourself. The start to this is selecting one of the following image source selection modes available for your display:
Automatic | In this mode, your display automatically |
| detects the connected video input signals, |
| attaches them to the correct display side |
| and applies the correct video settings to it |
| (resolution, video encoding mode, refresh |
| rate,...). |
| No video settings are available when this |
| mode is selected. |
|
|
One Image Source | This mode is intended for displaying and |
| manually configuring only one connected |
| video input signal. |
| When selecting this mode, the video |
| settings become available for the selected |
| video input signal. |
|
|
Two Image Sources | This mode is intended for displaying and |
| manually configuring two connected video |
| input signals (one on each display side). |
| When selecting this mode, the video |
| settings become available for the selected |
| video input signal on each side of the |
| display. |
|
|
TO SELECT AN IMAGE SOURCE SELECTION MODE:
1Bring up the OSD main menu.
2Navigate to the Configuration > Image Sources menu.
3Enter the Image Source Selection submenu.
4Select one of the available image source selection modes and confirm.