Video timings
ABOUT VIDEO TIMINGS
Your CORONIS FUSION 10MP display automatically detects the connected video input signals and applies the correct timings. Manually configuring the video timings is possible, but then your display’s image source selection mode should be set to allow this. Please refer to “Image source selection modes” on page 36 to do this.
Following video timings are available for your CORONIS FUSION 10MP display:
Resolution | Allows to manually modify the resolution |
| of the image source video input signal. |
|
|
Refresh Rate | Allows to manually select the refresh rate |
| of the image source video input signal |
| depending on the maximum refresh rate of |
| the display controller connected to your |
| display. |
|
|
Orientation | Allows to change the orientation of the |
| image source video input signal to |
| landscape, portrait or to let the display |
| automatically assign the correct |
| orientation. |
|
|
TO MANUALLY SET VIDEO TIMINGS:
1Bring up the OSD main menu.
2Navigate to the Configuration > Image Sources > (Left/Right) Image Source menu.
3Enter the Timings submenu.
4Select Resolution, Refresh Rate or Orientation.
5Select one of the available settings and confirm.