Video input signals
ABOUT VIDEO INPUT SIGNALS
Your CORONIS FUSION 10MP display automatically detects the connected video input signals. Manually selecting image source video input signals is possible, but then your display’s image source selection mode should be set to allow this. Please refer to “Image source selection modes” on page 36 to do this.
The available input signals for your display are:
DisplayPort 1 | This input corresponds to the DisplayPort 1 |
| connector as shown in the “Parts, controls |
| and connectors” section. |
|
|
DVI 1 | This input corresponds to the DVI 1 |
| connector as shown in the “Parts, controls |
| and connectors” section. |
|
|
DisplayPort 2 | This input corresponds to the DisplayPort 2 |
| connector as shown in the “Parts, controls |
| and connectors” section. |
|
|
DVI 2 | This input corresponds to the DVI 2 |
| connector as shown in the “Parts, controls |
| and connectors” section. |
|
|
TO MANUALLY SELECT A VIDEO INPUT SIGNAL:
1Bring up the OSD main menu.
2Navigate to the Configuration > Image Sources > (Left/Right) Image Source menu.
3Enter the Input Signal submenu.
4Select one of the available input signals and confirm.