TRENDnet S4W1CA Firmware Upgrade, Configuration Tools, Restore Factory Default, Backup Settings

Contents CE Mark Warning FCC WarningVCCI Warning TABLE OF CONTENTS ABOUT THIS GUIDE INTRODUCTION Broadband Internet access sharingResource sharing File sharingUNPACKING AND SETUP 4-Port 10/100Mbps Ethernet Broadband Router Front Panel POWER HARDWARE INSTALLATIONRESET STATUSConnect the Internet Broadband Router Check the installationPC NETWORK TCP/IP SETTING 1. Right click My Network Places and select Properties INTERNET BROADBAND ROUTER CONFIGURATION The Maximum Idle Time feature can The MTU feature specifies the largest packet size permitted for1-2-1 Dynamic IP Cable Modem If required by your ISP, input a host name and MAC address2-1-2 Administrator Settings Password Settings Advanced Setup1-3 DNS addresses2-1-4 Configuration Tools 2-1-3 Firmware UpgradeRestore Factory Default Backup SettingsIf your ISP is BigPond Australia, check the Enable box 2-1-7 Reset 2-2 WAN2-2-1 Dynamic IP 2-2-2 Static IPService Provider Use Dynamic DNS Check this option to enable Dynamic DNSSelect a Dynamic DNS service provider from the dropdown list 2-2-4 PPTPPassword Enter the username provided by your Dynamic DNS service providerEnter the password provided by your Dynamic DNS service provider 2-3 LAN To set the LAN’s IP Address 2-3-1 LAN SettingsExample 2-5 Firewall To block certain client PCs from accessing the Internet2-5-1 Discard PING from WAN side 2-5-2 Client FilteringTECHNICAL SPECIFICATIONS TW100-S4W1CA LIMITED WARRANTYFive years