TRENDnet S4W1CA manual Connect the Internet Broadband Router, Check the installation

Page 7

Connect the Internet Broadband Router

Hardware connections

Connect the Internet Broadband Router

1.Connect one end of the network cable to the WAN port of the 4-port Internet Broadband Router.

2.Connect the other end of the network cable to the Ethernet port of the xDSL or Cable modem.

3.Connect one end of another network cable to the computer’s Ethernet card and the other end of the cable to one of the Router’s LAN ports. Since the Internet Broadband Router has four ports, you can connect up to four computers directly to the unit. You do not have to buy a switch to connect these computers since the Internet Broadband Router functions as both an Internet connection-sharing unit and as a switch.

Check the installation

The LEDs of the Internet Broadband Router are clearly visible and the status of the network link can be seen immediately:

1.Once the device is connected to the broadband modem and the Power is connected, the Power, System, LAN and WAN port link LEDs of the Internet Broadband Router will light up.

2.If the WAN port is linked to the ADSL/Cable modem, the WAN port’s Link/ACT LED will light up.

3.If the LAN port is linked to the computer system, the LAN port’s Link/ACT LED will light up.

9

10

Image 7

Contents CE Mark Warning FCC WarningVCCI Warning TABLE OF CONTENTS ABOUT THIS GUIDE File sharing Broadband Internet access sharingINTRODUCTION Resource sharingUNPACKING AND SETUP STATUS HARDWARE INSTALLATION4-Port 10/100Mbps Ethernet Broadband Router Front Panel POWER RESETConnect the Internet Broadband Router Check the installationPC NETWORK TCP/IP SETTING 1. Right click My Network Places and select Properties INTERNET BROADBAND ROUTER CONFIGURATION If required by your ISP, input a host name and MAC address The MTU feature specifies the largest packet size permitted forThe Maximum Idle Time feature can 1-2-1 Dynamic IP Cable Modemaddresses Advanced Setup2-1-2 Administrator Settings Password Settings 1-3 DNSBackup Settings 2-1-3 Firmware Upgrade2-1-4 Configuration Tools Restore Factory Default2-2-2 Static IP 2-1-7 Reset 2-2 WANIf your ISP is BigPond Australia, check the Enable box 2-2-1 Dynamic IP2-2-4 PPTP Use Dynamic DNS Check this option to enable Dynamic DNSService Provider Select a Dynamic DNS service provider from the dropdown list2-3 LAN To set the LAN’s IP Address 2-3-1 LAN Settings Enter the username provided by your Dynamic DNS service providerPassword Enter the password provided by your Dynamic DNS service providerExample 2-5-2 Client Filtering To block certain client PCs from accessing the Internet2-5 Firewall 2-5-1 Discard PING from WAN sideTECHNICAL SPECIFICATIONS TW100-S4W1CA LIMITED WARRANTYFive years