TRENDnet S4W1CA manual Technical Specifications

Page 19
TECHNICAL SPECIFICATIONS

2-5-4 DMZ (Demilitarized Zone)

If a local client PC cannot run an Internet application properly from behind the NAT firewall, open the client up to unrestricted two-way Internet access by defining a PC as a virtual DMZ Host.

2-6 Routing

2-6-1 Static Routing

Static routing determines the path that data follows over your network before and after it passes through your router. You can use static routing to allow different IP domain users to access the Internet through the device

TECHNICAL SPECIFICATIONS

 

General

 

 

Standards

IEEE 802.3 10BASE-T Ethernet

 

IEEE 802.3u 100BASE-TX Fast Ethernet

 

ANSI/IEEE 802.3 Auto-negotiation

 

 

Protocol

CSMA/CD

 

 

Data Transfer

Ethernet: 10Mbps (half duplex), 20Mbps (full-duplex)

Rate

Fast Ethernet: 100Mbps (half duplex), 200Mbps (full- duplex)

 

 

 

Topology

Star

 

 

Network

10BASET: 2-pair UTP Cat. 3,4,5 (100 m), EIA/TIA- 568 100-

Cables

ohm STP (100 m)

 

100BASE-TX: 2-pair UTP Cat. 5 (100 m), EIA/TIA-568 100-ohm

 

STP (100 m)

 

 

Number of

LAN: 4 x 10/100Mbps Auto-MDIX Fast Ethernet port

Ports

WAN: 1 x 10/100Mbps Auto-MDIX Fast Ethernet port

 

 

 

 

Physical and Environmental

 

 

DC inputs

Switching Power 5V 800mA or Linear Power 9V 800mA

 

 

Power

3W (Max)

Consumption

 

 

 

Temperature

Operating: 0° ~ 40° C, Storage: -10°~ 70° C

 

 

Humidity

Operating: 10% ~ 90%, Storage: 5% ~ 90%

 

 

Dimensions

154 x 110 x 33mm (6 x 4.3 x 1.3 inches)

 

 

EMI:

FCC, CE

 

 

33

 

34

Image 19
Contents CE Mark Warning FCC WarningVCCI Warning TABLE OF CONTENTS ABOUT THIS GUIDE File sharing Broadband Internet access sharingINTRODUCTION Resource sharingUNPACKING AND SETUP STATUS HARDWARE INSTALLATION4-Port 10/100Mbps Ethernet Broadband Router Front Panel POWER RESETConnect the Internet Broadband Router Check the installationPC NETWORK TCP/IP SETTING 1. Right click My Network Places and select Properties INTERNET BROADBAND ROUTER CONFIGURATION If required by your ISP, input a host name and MAC address The MTU feature specifies the largest packet size permitted forThe Maximum Idle Time feature can 1-2-1 Dynamic IP Cable Modemaddresses Advanced Setup2-1-2 Administrator Settings Password Settings 1-3 DNSBackup Settings 2-1-3 Firmware Upgrade2-1-4 Configuration Tools Restore Factory Default2-2-2 Static IP 2-1-7 Reset 2-2 WANIf your ISP is BigPond Australia, check the Enable box 2-2-1 Dynamic IP2-2-4 PPTP Use Dynamic DNS Check this option to enable Dynamic DNSService Provider Select a Dynamic DNS service provider from the dropdown list2-3 LAN To set the LAN’s IP Address 2-3-1 LAN Settings Enter the username provided by your Dynamic DNS service providerPassword Enter the password provided by your Dynamic DNS service providerExample 2-5-2 Client Filtering To block certain client PCs from accessing the Internet2-5 Firewall 2-5-1 Discard PING from WAN sideTECHNICAL SPECIFICATIONS TW100-S4W1CA LIMITED WARRANTYFive years