TRENDnet S4W1CA Reset 2-2 WAN, Dynamic IP, If your ISP is BigPond Australia, check the Enable box

Page 14
2-1-7 Reset

2-1-7 Reset

2-2 WAN

The Broadband Router supports the following types of Internet connections: Dynamic IP Address, Static IP Address, PPPoE, and PPTP.

2-2-1 Dynamic IP

The Host Name is optional, but may be required by some Service Providers. The default MAC address is set to the WAN's physical interface on the Broadband Router. If the Service Provider requires the MAC address, type it in. Click the "Clone MAC Address" button to copy the MAC address of the Network Interface Card installed in the PC. The WAN MAC address will be replaced by this MAC address.

If your ISP is BigPond (Australia), check the Enable box.

23

2-2-2 Static IP

If the Service Provider has assigned a fixed IP address, enter the assigned IP address subnet mask and gateway address provided. Click “yes” if are using two or more IP addresses.

2-2-3 PPPoE (Dial-up xDSL)

If you’re connecting to the Internet using a PPPoE (Dial- up xDSL) Modem and your ISP has provided you with a Password and Username, then your ISP uses PPPoE. Select this option, and enter the required information. If the ISP provided a Service Name, enter it in the Service Name field. Otherwise, leave it blank.

The Service Name, IP Address, and DNS Address fields must be completed if your ISP provides you with this information. If your ISP provides a Dynamic IP Address, skip these fields.

24

Page 13 Page 15
Image 14
Page 13 Page 15
Contents VCCI Warning FCC WarningCE Mark Warning TABLE OF CONTENTS ABOUT THIS GUIDE Resource sharing Broadband Internet access sharingINTRODUCTION File sharingUNPACKING AND SETUP RESET HARDWARE INSTALLATION4-Port 10/100Mbps Ethernet Broadband Router Front Panel POWER STATUSCheck the installation Connect the Internet Broadband RouterPC NETWORK TCP/IP SETTING 1. Right click My Network Places and select Properties INTERNET BROADBAND ROUTER CONFIGURATION 1-2-1 Dynamic IP Cable Modem The MTU feature specifies the largest packet size permitted forThe Maximum Idle Time feature can If required by your ISP, input a host name and MAC address1-3 DNS Advanced Setup2-1-2 Administrator Settings Password Settings addressesRestore Factory Default 2-1-3 Firmware Upgrade2-1-4 Configuration Tools Backup Settings2-2-1 Dynamic IP 2-1-7 Reset 2-2 WANIf your ISP is BigPond Australia, check the Enable box 2-2-2 Static IPSelect a Dynamic DNS service provider from the dropdown list Use Dynamic DNS Check this option to enable Dynamic DNSService Provider 2-2-4 PPTPEnter the password provided by your Dynamic DNS service provider Enter the username provided by your Dynamic DNS service providerPassword 2-3 LAN To set the LAN’s IP Address 2-3-1 LAN SettingsExample 2-5-1 Discard PING from WAN side To block certain client PCs from accessing the Internet2-5 Firewall 2-5-2 Client FilteringTECHNICAL SPECIFICATIONS Five years LIMITED WARRANTYTW100-S4W1CA
Top Page Image Contents