TRENDnet S4W1CA manual Hardware Installation, Status, LAN Link/ACT, Reset

Page 6
HARDWARE INSTALLATION

HARDWARE INSTALLATION

Front Panel

The figure below shows the front panel of the Broadband Router.

4-Port 10/100Mbps Ethernet Broadband Router Front Panel

POWER

This indicator lights green when the hub is receiving power. Otherwise, it is off.

STATUS

This indicator blinks red when the Internet Broadband Router is successfully working. If the indicator is either always on or off, the Internet Broadband Router is not working properly.

WAN

This indicator lights green when the WAN port is connected to an xDSL/Cable modem successfully.

This indicator blinks green while the WAN port is transmitting data to or receiving data from the xDSL/Cable modem.

LAN (Link/ACT)

The port 1 - 4 indicators light green when they’re connected to a 100Mbps Fast Ethernet station. If the indicator blinks green, the corresponding LAN port is transmitting or receiving data.

Rear Panel

The figure below shows the rear panel of the Broadband Router.

4 Port 10/100Mbps Ethernet Broadband Router Rear Panel

WAN

On the 4 port broadband router, there is an RJ-45 10/100Mbps Auto- MDIX WAN port. This port connects to your xDSL/Cable modem.

LAN (1-4)

Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either 10Mbps or 100Mbps Ethernet connections.

RESET

Use a pin-shaped object to reset this device to factory default settings. Resetting the device will also reset the login password to the default.

7

 

8

Page 5 Page 7
Image 6
Page 5 Page 7
Contents FCC Warning CE Mark WarningVCCI Warning TABLE OF CONTENTS ABOUT THIS GUIDE Resource sharing Broadband Internet access sharingINTRODUCTION File sharingUNPACKING AND SETUP RESET HARDWARE INSTALLATION4-Port 10/100Mbps Ethernet Broadband Router Front Panel POWER STATUSCheck the installation Connect the Internet Broadband RouterPC NETWORK TCP/IP SETTING 1. Right click My Network Places and select Properties INTERNET BROADBAND ROUTER CONFIGURATION 1-2-1 Dynamic IP Cable Modem The MTU feature specifies the largest packet size permitted forThe Maximum Idle Time feature can If required by your ISP, input a host name and MAC address1-3 DNS Advanced Setup2-1-2 Administrator Settings Password Settings addressesRestore Factory Default 2-1-3 Firmware Upgrade2-1-4 Configuration Tools Backup Settings2-2-1 Dynamic IP 2-1-7 Reset 2-2 WANIf your ISP is BigPond Australia, check the Enable box 2-2-2 Static IPSelect a Dynamic DNS service provider from the dropdown list Use Dynamic DNS Check this option to enable Dynamic DNSService Provider 2-2-4 PPTPEnter the password provided by your Dynamic DNS service provider Enter the username provided by your Dynamic DNS service providerPassword 2-3 LAN To set the LAN’s IP Address 2-3-1 LAN SettingsExample 2-5-1 Discard PING from WAN side To block certain client PCs from accessing the Internet2-5 Firewall 2-5-2 Client FilteringTECHNICAL SPECIFICATIONS LIMITED WARRANTY TW100-S4W1CAFive years
Top Page Image Contents