SATO D508, D512 service manual Optional Accessories

Page 11

Section 1: Introduction

 

Optional Accessories

 

220V Power Supply

 

Auto-switching

Internal Cutter

 

User or factory installed Internal option allowing

 

 

labels to be cut at specified intervals.

IEEE1284 Interface

 

Parallel interface. Factory or User installable

Serial Interface

 

High Speed RS232 Interface option, 9600 bps to

 

 

57.6 Kbps. Factory or User installable.

LAN Interface

 

TCP/IP Protocol Interface option. Factory or User

 

 

installable.

USB Interface

 

Universal Serial Bus Interface option. Factory or

 

 

User installable.

RFID

 

To be announced

Wireless LAN Interface

 

802.11 b/g

*All specifications subject to change without notice.

SATO D508/D512 Operator Manual

Page 1-7

Image 11
Contents OperatorSvice Manual Sato America, Inc Table of Contents Sato Group of companies TroubleshootingSato Contacts Overview Introduction General Printer SpecificationsAttribute General Printer SpecificationsMedia General Specifications CONT’DAttributes Barcodes Optional Accessories Introduction Sato D508/D512 Operator Manual Installation Electrical Precautions Printer Placement TipsGeneral Precautions Unpacking Printer Part Names Follow these steps to set up your printer Setting UP the PrinterLoading Media Fanfold media Overview of the fanfold-paper loading path Label SensingThis page is left blank intentionally Operating Panel Rear Panel DIP Switch Settings Configuration PanelSwitch 4 Unused DIP Switch Settings CONT’DSwitch 7 Data Dump Switch 8 Unused Error Codes Offsets Mode Length of Offset mm Print head resolutionMoved with Leading Edge Positive + Offset Potentiometer AdjustmentsPitch Offset Original First Line Print PositionPrint Darkness Potentiometer Adjustments CONT’DData Dump Diagnostic Label Printing Test Labels Printing FACTORY/SERVICE Test Prints Configuration and Operation Sato D508/D512 Operator Manual Introduction Adjusting the Print QualityCleaning the Print HEAD, Platen and Rollers Cleaning the Print HEAD, Platen and Rollers CONT’D RELEASING/REPLACING the Print Head Cleaning the Sensor This page is left blank intentionally Interface Types Interface SpecificationsSingle Job Buffer Receive BufferMulti Job Buffer Receive Buffer CONT’DIEEE1284 Parallel Interface PIN Signal DirectionRS-232C Interface General SpecificationsPin Direction Signal Definition 1 RS-232C Interface SignalsLocal Area Network Interface READY/BUSY Flow ControlON/X-OFF Flow Control Universal Serial BUS InterfaceSwitch Setting Wireless LAN Interface 802.11 B/GSpecifications Software Specifications LED Indicator StatusInterface Specifications Observations Initial ChecklistChecking the IEEE1284 Parallel Interface Using the IEEE1284 Parallel Interface CONT’D Obserations Checking Using the Parallel Interface CONT’DChecking the RS232C Serial Interface LED Indicators Buzzer Error Condition Corrective Action Error SignalsChecking the 802.11G Wireless Interface Sato Contacts Asia Pacific & Oceania Region Sato Group of Companies