SATO D508, D512 service manual Configuration Panel, DIP Switch Settings

Page 25

Section 3: Configuration and Operation

3.3 THE CONFIGURATION PANEL

The Configuration Panel is accessible when you lift up the top cover.

The panel consists of an eight-position DIP switch, four adjustment potentiometers and a seven- segment LED Error Status display. Receptacles for connecting the optional Cutter (factory installed) are also located on this panel.

Change and fine-tune your printer settings as required by using the mini-screw driver to turn the potentiometers clockwise/anti-clockwise until you have the optimal adjustment position.

Do not touch VR2 and VR3. They are reserved for professional adjustments and for a trained service person only.

VR4

 

Label Pitch

 

Offset

 

VR1

DIP switch for

Offset or

Darkness

Configuration

 

VR2

 

VR3

 

Error

Paper handling

Status

LED

Reserved

Head Check

 

VR1 adjust

 

DATA Dump

 

Reserved

 

DIP SWITCH SETTINGS

This is an eight-position switch used for setting the operating conditions of the printer. Switches 1 to 3 act as control for both paper handling and the loading of programs or fonts into the printer.

SATO D508/D512 Operator Manual

Page 3-3

Image 25
Contents OperatorSvice Manual Sato America, Inc Table of Contents Sato Contacts TroubleshootingSato Group of companies Overview Introduction General Printer SpecificationsAttribute General Printer SpecificationsMedia General Specifications CONT’DAttributes Barcodes Optional Accessories Introduction Sato D508/D512 Operator Manual Installation Electrical Precautions Printer Placement TipsGeneral Precautions Unpacking Printer Part Names Follow these steps to set up your printer Setting UP the PrinterLoading Media Fanfold media Overview of the fanfold-paper loading path Label SensingThis page is left blank intentionally Operating Panel Rear Panel DIP Switch Settings Configuration PanelSwitch 4 Unused DIP Switch Settings CONT’DSwitch 7 Data Dump Switch 8 Unused Error Codes Offsets Mode Length of Offset mm Print head resolutionPitch Offset Potentiometer AdjustmentsOriginal First Line Print Position Moved with Leading Edge Positive + OffsetPrint Darkness Potentiometer Adjustments CONT’DData Dump Diagnostic Label Printing Test Labels Printing FACTORY/SERVICE Test Prints Configuration and Operation Sato D508/D512 Operator Manual Introduction Adjusting the Print QualityCleaning the Print HEAD, Platen and Rollers Cleaning the Print HEAD, Platen and Rollers CONT’D RELEASING/REPLACING the Print Head Cleaning the Sensor This page is left blank intentionally Interface Types Interface SpecificationsSingle Job Buffer Receive BufferMulti Job Buffer Receive Buffer CONT’DIEEE1284 Parallel Interface PIN Signal DirectionRS-232C Interface General SpecificationsPin Direction Signal Definition 1 RS-232C Interface SignalsON/X-OFF Flow Control READY/BUSY Flow ControlUniversal Serial BUS Interface Local Area Network InterfaceSpecifications Wireless LAN Interface 802.11 B/GSwitch Setting Software Specifications LED Indicator StatusInterface Specifications Checking the IEEE1284 Parallel Interface Initial ChecklistObservations Using the IEEE1284 Parallel Interface CONT’D Obserations Checking Using the Parallel Interface CONT’DChecking the RS232C Serial Interface LED Indicators Buzzer Error Condition Corrective Action Error SignalsChecking the 802.11G Wireless Interface Sato Contacts Asia Pacific & Oceania Region Sato Group of Companies