SATO D512, D508 service manual Offsets, Mode Length of Offset mm Print head resolution

Page 30

Section 3: Configuration and Operation

3.5 OFFSETS

There are two offset settings stored in the printer; one for the Cut mode and one for the Tear-Off mode.

These two offsets can be set independently and will remain in the printer until a new command is received changing the setting or until power is turned off.

The default settings can be determined by printing a User Test Label.

The following should be used as starting points for establishing the three Offset values:

Mode	Length of Offset (mm)	Length of Offset (in)	Print head resolution


CUTTER	17.9	0.70	143/215
TEAR-OFF	29.2	1.15	234/350

Page 3-8

SATO D508/D512 Operator Manual

Image 30

Contents OperatorSvice Manual Sato America, Inc Table of Contents Troubleshooting Sato ContactsSato Group of companies Overview General Printer Specifications IntroductionGeneral Printer Specifications AttributeGeneral Specifications CONT’D MediaAttributes Barcodes Optional Accessories Introduction Sato D508/D512 Operator Manual Installation Printer Placement Tips Electrical PrecautionsGeneral Precautions Unpacking Printer Part Names Setting UP the Printer Follow these steps to set up your printerLoading Media Fanfold media Label Sensing Overview of the fanfold-paper loading pathThis page is left blank intentionally Operating Panel Rear Panel Configuration Panel DIP Switch SettingsDIP Switch Settings CONT’D Switch 4 UnusedSwitch 7 Data Dump Switch 8 Unused Error Codes Mode Length of Offset mm Print head resolution OffsetsOriginal First Line Print Position Potentiometer AdjustmentsPitch Offset Moved with Leading Edge Positive + OffsetPotentiometer Adjustments CONT’D Print DarknessData Dump Diagnostic Label Printing Test Labels Printing FACTORY/SERVICE Test Prints Configuration and Operation Sato D508/D512 Operator Manual Adjusting the Print Quality IntroductionCleaning the Print HEAD, Platen and Rollers Cleaning the Print HEAD, Platen and Rollers CONT’D RELEASING/REPLACING the Print Head Cleaning the Sensor This page is left blank intentionally Interface Specifications Interface TypesReceive Buffer Single Job BufferReceive Buffer CONT’D Multi Job BufferPIN Signal Direction IEEE1284 Parallel InterfaceGeneral Specifications RS-232C Interface1 RS-232C Interface Signals Pin Direction Signal DefinitionUniversal Serial BUS Interface READY/BUSY Flow ControlON/X-OFF Flow Control Local Area Network InterfaceWireless LAN Interface 802.11 B/G SpecificationsSwitch Setting LED Indicator Status Software SpecificationsInterface Specifications Initial Checklist Checking the IEEE1284 Parallel InterfaceObservations Using the IEEE1284 Parallel Interface CONT’D Checking Using the Parallel Interface CONT’D ObserationsChecking the RS232C Serial Interface Error Signals LED Indicators Buzzer Error Condition Corrective ActionChecking the 802.11G Wireless Interface Sato Contacts Sato Group of Companies Asia Pacific & Oceania Region