SECTION 2: INSTALLATION
2.1 UNPACKING
When unpacking the printer, take note of the following:
|
| The box should stay |
|
| If the printer has been stored in the |
1 | 4 | ||||
|
| Lift the printer out of the box carefully. |
|
| cold, allow it to reach room |
|
|
|
|
| temperature before turning it on. |
|
|
|
|
|
|
|
| Remove the plastic covering from the |
|
| Set the printer on a solid, flat surface. |
2 | 5 | ||||
|
| printer. |
|
| Inspect the shipping container and |
|
|
|
|
| printer for any sign of damage that |
|
|
|
|
| may have occurred during shipping. |
|
| Remove the accessory items from their |
|
| |
| 3 |
|
|
| |
|
| protective containers. |
|
|
|
|
|
|
|
|
|
Note:
The following parts shown here are representative only. Due to regional requirements and our policy of continual improvement, your printer may not be packed with the exact parts as shown here, but the unpacking steps are similar.
Printer | AC adaptor and cable |
User documentation and software
package (where applicable)
Page | SATO D508/D512 Operator Manual |