SATO 5900RVe manual Unpacking & Parts Identification, Packed Components

Page 16

Unit 3: Installation

UNPACKING & PARTS IDENTIFICATION

Unpack the printer as directed in the following procedure.

1Place the shipping container (box) upright on a solid, flat surface.

2Open the box, remove any loose items and the first layer of packing material.

3Carefully lift the printer and accessories from the box and place them on a solid flat surface.

4Remove the plastic covers from the printer and its accessories.

5Inspect the printer and its accessories for visual physical damage.

6Ensure the following components are present:

7Report damaged property.

PACKED COMPONENTS

Printer

Power Cord

Operator Manual

Programming Manual

Software Disk

SATO M5900RVe Operator Manual

PN 9001125A

Page 3-2

Image 16

Contents M5900RVe Direct Thermal Printer Sato America, Inc Table of Contents Maintenance TroubleshootingOperation Introduction About this Manual Result in Presonal InjuryGeneral Description 1a, Primary Components1b, Primary Components Control Features SwitchesPage Technical Data Physical Characteristics PowerEnvironmental PrintCharacter Font Capabilities Downloadable Fonts Character ControlBAR Code Capabilties Regulatory ApprovalsInstallation Unpacking & Parts Identification Packed ComponentsPrinter Installation Site LocationMedia Selection Media LoadingMedia Loading Interface Selection RS232C SpecificationsRS232 Serial Interface RS232C Serial Interface Signals PIN Direction Signal DefinitionCable Requirements DB9 Host Connection DB9 PrinterSpecifications IEEE1284 Parallel InterfaceACK Init802.11B Wireless 80211B Wireless SpecificationsUniversal Serial BUS USB Adapter Local Area Network LAN EthernetReceive Buffer ACK/NAK ProtocolAccessories Installation Interface Module UpgradeOperation Printer Configuration DIP Switch PanelsDSW1 Default Settings DSW1 ConfigurationDSW1 Function Descriptions OFFDSW2 Default Settings DSW2 Configuration DSW1Configuration DSW2 Function DescriptionsDSW3 Default Settings Function DescriptionConfiguration Modes Normal ModeTest Print Mode Test Print ModeAdvanced Mode Advanced ModeDefault Settings Mode Default Settings ModeFlash Memory Download Mode Download Font Deletion Status Description Acsii HEX TransferFlash Memory Download Mode User Download Mode User Download ModeHEX Dump Mode Hex Dump ModeCard Mode Card ModeNON-STANDARD Clear Mode Non-Standard Clear ModeService Mode 10, Service ModeCounters Mode 11, Counters ModeMaintenance Mode Maintenance ModeCard Mode Advanced ModeMenu Description Service Mode Counters Mode Maintenance Mode Operational Adjustments Potentiometer DESCRIPTION/PROCEDUREPrint OffsetFeed Direction 14, Sensor & Accessory Locations Unit 4 Operation Sato M5900RVe Operator Manual PN 9001125A Troubleshooting LCD Message Beep Error Condition To Clear Image Voids Light Print ImagesUneven Print Darkness Smeared Print ImagesPrinter Creates a Blank Label Meandering MediaIncorrect Label Positioning Troubleshooting Procedures Universal Serial BUS USB Interface Parallel InterfaceLAN Ethernet Interface Page Maintenance Cleaning Procedures From the PRINTER, Exersize Care to Prevent Print Head DamageReplacement Procedures Fuse ReplacementPrint Head Replacement Print Head to Prevent Damage to ITS ElementsInterface Board Replacement Interface Board ReplacementAdjustment Procedures Print Defects Relative ProcedurePrint Head Balance Adjustment Print Head Balance AdjustmentPrint Head Alignment Print Head Alignment