SATO 5900RVe manual Accessories Installation, Interface Module Upgrade

Page 24

Unit 3: Installation

ACCESSORIES INSTALLATION

In most instances, the printer is ordered with the desired accessories pre-installed. However, changes in printing conditions or requirements does warrant upgrades from time to time.

This chapter of the manual covers the installation procedures of accessories that are deemed suitable for the owner/operator to perform. For all other accessory upgrades or installatins, contact the SATO Technical Support Dept.

INTERFACE MODULE UPGRADE

The printer is typically ordered with a high-speed parallel interface board installed. However, interface requirements sometimes change and an upgrade is desired. All of the interface boards are installed within the same slot located in the rear of the printer with little or no difference in installation methodology.

Simply remove the two screws (1) securing the existing interface board (2) to the printer (3). Replace the exisiting board with the upgrade and secure with the two screws.

2

1

3

Figure 3-3, Interface Board Upgrade

SATO M5900RVe Operator Manual

PN 9001125A

Page 3-10

Image 24

Contents M5900RVe Direct Thermal Printer Sato America, Inc Table of Contents Troubleshooting MaintenanceOperation Introduction About this Manual Result in Presonal InjuryGeneral Description 1a, Primary Components1b, Primary Components Control Features SwitchesPage Technical Data Physical Characteristics PowerEnvironmental PrintCharacter Font Capabilities Downloadable Fonts Character ControlBAR Code Capabilties Regulatory ApprovalsInstallation Unpacking & Parts Identification Packed ComponentsPrinter Installation Site LocationMedia Selection Media LoadingMedia Loading RS232C Specifications Interface SelectionRS232 Serial Interface RS232C Serial Interface Signals PIN Direction Signal DefinitionCable Requirements DB9 Host Connection DB9 PrinterSpecifications IEEE1284 Parallel InterfaceACK Init802.11B Wireless 80211B Wireless SpecificationsUniversal Serial BUS USB Adapter Local Area Network LAN EthernetReceive Buffer ACK/NAK ProtocolAccessories Installation Interface Module UpgradeOperation Printer Configuration DIP Switch PanelsDSW1 Default Settings DSW1 ConfigurationDSW1 Function Descriptions OFFDSW2 Default Settings DSW2 Configuration DSW1Configuration DSW2 Function DescriptionsDSW3 Default Settings Function DescriptionConfiguration Modes Normal ModeTest Print Mode Test Print ModeAdvanced Mode Advanced ModeDefault Settings Mode Default Settings ModeFlash Memory Download Mode Download Font Deletion Status Description Acsii HEX TransferFlash Memory Download Mode User Download Mode User Download ModeHEX Dump Mode Hex Dump ModeCard Mode Card ModeNON-STANDARD Clear Mode Non-Standard Clear ModeService Mode 10, Service ModeCounters Mode 11, Counters ModeMaintenance Mode Maintenance ModeAdvanced Mode Card ModeMenu Description Service Mode Counters Mode Maintenance Mode Operational Adjustments Potentiometer DESCRIPTION/PROCEDUREPrint OffsetFeed Direction 14, Sensor & Accessory Locations Unit 4 Operation Sato M5900RVe Operator Manual PN 9001125A Troubleshooting LCD Message Beep Error Condition To Clear Image Voids Light Print ImagesUneven Print Darkness Smeared Print ImagesMeandering Media Printer Creates a Blank LabelIncorrect Label Positioning Troubleshooting Procedures Universal Serial BUS USB Interface Parallel InterfaceLAN Ethernet Interface Page Maintenance Cleaning Procedures From the PRINTER, Exersize Care to Prevent Print Head DamageReplacement Procedures Fuse ReplacementPrint Head Replacement Print Head to Prevent Damage to ITS ElementsInterface Board Replacement Interface Board ReplacementAdjustment Procedures Print Defects Relative ProcedurePrint Head Balance Adjustment Print Head Balance AdjustmentPrint Head Alignment Print Head Alignment