SATO 5900RVe manual Control Features, Switches

Unit 1: Introduction

CONTROL FEATURES

SWITCHES

Power Switch	Two position on/off switch that controls power flow to the system.
Line Key	Toggles between on-line and off-line modes. When on-line, the
	printer is ready to receive data from the host. Acts as a pause during
	print by taking the printer off-line. Also used as a scroll-and-enter
	interface for printer setup.
Feed Key	Feeds one blank label through the printer when off-line. When the
	printer is on-line, another copy of the last label will be printed. Also
	used as a scroll-and-enter interface for printer setup.
DSW2 & DSW3	Sets operational parameters of printer.
DSW1	To configure optional RS232 communication card. Located on card.
CONNECTION PORTS
AC Power Input	Connector permits 115V, 50/60 Hz supply via supplied cord.
Interface Port	Connector for interface harness. Must be connected for the printer to
	be operational. Acceptable interface types are:
	• RS232C Serial I/F Module, DB-25
	• IEEE1284 Parallel I/F Module, AMP 57-40360
	• Universal Serial Bus Adapter
	• Ethernet 10/100 BaseT I/F Module
	• RS422/485 I/F Module, DB-9
Ext. Interface Port	Connector for external control of print cycle. Also supplies power for
	optional accessories - AMP 57-60140
Memory Card Slot	Slot for the insertion of optional PCMCIA Memory Card

LCD DISPLAY

LINE KEY

LINEFEED

PRINT OFFSET PITCH

DSW2DSW3

FEED KEY

POTENTIOMETERS

DIP SWITCHES

MEMORY CARD SLOT

I/F

EXT.

POWER

FUSE T3.15A H 250V

100V - 120V

INTERFACE PORT

EXT PORT

POWER SWITCH

MAIN FUSE CONNECTION AC POWER INPUT

PANEL COVERREAR COVER

Figure 1-2, Switches, Indicators, and Connection Ports

SATO M5900RVe Operator Manual PN 9001125A Page 1-5