SATO 5900RVe manual DSW3 Default Settings, Function Description

Unit 4: Operation

DSW3 DEFAULT SETTINGS

3-1		3-2	3-3			3-4		3-5	3-6	3-7	3-8
OFF		OFF	OFF			OFF		OFF	OFF	OFF	OFF
					DSW3 CONFIGURATION
					3-1		3-2
3-1					OFF		OFF	Batch/Continuous
		Operating Mode			OFF		ON	Tear Off
3-2
					ON		OFF	Cutter
					ON		ON	Dispenser
3-3		Label Sensor				OFF		Sensor Used
						ON		Sensor Not Used
3-4		Backfeed				OFF		Enabled
						ON		Disabled
3-5		Print Start Signal				OFF		Disabled
						ON		Enabled
					3-6		3-7
3-6					OFF		OFF	Type 4
	External Signal Type
					OFF		ON	Type 3
3-7
					ON		OFF	Type 2
					ON		ON	Type 1
3-8	Repeat Print via Ext					OFF		Disabled
		Signal				ON		Enabled
			DSW3 FUNCTION DESCRIPTIONS
	FUNCTION							DESCRIPTION
Operating Mode				Batch/Continuous, Tear-Off, Cutter, Dispenser
Label Sensor				Enabled, detects the label’s edge and positions it automatically.
				Disabled, it is under software control.
Back Feed				Enabled, positions the last printed label for dispensing and retracts
				the media for printing the next.
				Allows an external device to initiate a label print for synchronization
Print Start Signal				with the applicator. When on, the unit is in the Continuous print mode,
				Backfeed is disabled and External Signals are ignored.
External Signal				Refer to the Interface Specifications unit for information.
Repeat Print External Signal				Allows an external device to repeat the print siquence.

SATO M5900RVe Operator Manual PN 9001125A Page 4-5