SATO MB200/201i manual Compliance Statement

Page 14

Introduction

Notes on Bluetooth/Wireless Communication

Compliance Statement

This product has been certified for compliance with the relevant radio interference regulations of your country or region. To ensure continued compliance, do not:

•Disassemble or modify this product

•Remove the certificate label (serial number seal) af- fixed to this product

Use of this product near microwave and/or other wire- less LAN equipment, or where static electricity or radio interference is present, may shorten the communica- tion distance, or even disable communication.

“Bluetooth” is a trademark of Bluetooth SIG, Inc., USA., and is used herein under licence.

Caution: Before using the wireless LAN interface, make all the security settings of the wireless LAN equipment are configured in accordance with the instructions supplied with the equipment.

1-2

Image 14

Contents MB200/201i Operator’sDirectPrinterThermalManual Version SI-MB20xi-01rA-02-05-OM Safety Precautions IiiExplanation of hazard symbols ExampleLiquids Foreign MatterAbnormal Conditions DisassemblyBattery care Power Supply Precautions ViiLocation PowerViii Hazardous partsLong periods of non usage Replacing the Battery PackMaintenance and Cleaning Do not disassemble or modify the printer Avoid placement in extreme temperaturesWhen the printer is being transported Use only the specified cablesSetupUnpacking ...........the printer 54-1 Key features IntroductionCompliance Statement Setup Part Names Part Names cont’d Power Functions of various partsCharging the battery pack with a charger Charging Time Charging the battery pack with the printer Removal Using the battery packInsertion Using the battery pack cont’d Using the optional AC Adapter for power Using the optional AC Adapter for power Installing the label roll Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Turning the printer OFF Operation and ConfigurationTurning the printer Performing a Test Print Printing via the RS-232C Interface Use the following procedure to print through IrDA interface Printing via the IrDA InterfacePrinting via the Wireless LAN Interface Check the DIP SwitchesPrinting via the Bluetooth Interface Synchronize Bluetooth settingsOnline Optional LCD screenAdjusting Display Contrast Optional LCD screen cont’dPrinting Procedure Adjusting printing for Non-separate labels Choosing the Label Dispensing mode Configuring Dispense mode Type OperationOther Printer Modes Head Check Setting and Online Command SettingNormal mode Test Print Mode Printer modes cont’dSetting Head Check Area cover must be left open Head Check Setting ModeSetting Online Command compatibility Cover must be left open Online Command Compatibility ModeOffset Configuration via Programming Position AdjustmentsOperation and Configuration Interface Specifications Other required settingsRS-232C settings Button held down Deactivate Head Check Interface Specifications Cleaning and Maintenance Cleaning the Print HeadCleaning the Platen and Peel Roller Troubleshooting What to do in caseStatus Troubleshooting Troubleshooting BasicOPTBASCSpecificationsIONALSPECIFICATINSACCESSORIES Basic Specifications & Optional AccessoriesPaper thickness Interfaces Mini DIN RS-232C IrDA communication Complies Switches Environmental Measure to prevent interference e.g., installing partitions Optional Accessories Battery ItemsOptional Accessories Portability enhancements Pass one end Optional Accessories cont’d Portability enhancements Basic Specifications & Optional Accessories Optional Accessories cont’d Connectivity options Factory-installed options