SATO MB200/201i manual Installing the label roll cont’d

Page 27

Setup

Installing the label roll (cont’d)

3.Lift up the label guide adjust dial cover and turn the dial till the label guides press loosely against label roll. Turn the label roll lightly by the hand and confirm that it rotates smoothly. Otherwise paper may not be fed correctly during operation. Close the dial cover.

*When replacing a label roll of the same width as that used previously, adjustment of the label guide is not necessary.

4.Close the cover after confirming that the leading edge of the label is outside the printer.

This completes the label installation for continuous mode operation.

2-13

Image 27
Contents MB200/201i Operator’sDirectPrinterThermalManual Version SI-MB20xi-01rA-02-05-OM Iii Safety PrecautionsExample Explanation of hazard symbolsForeign Matter LiquidsDisassembly Battery careAbnormal Conditions Vii Power Supply PrecautionsHazardous parts PowerViii LocationReplacing the Battery Pack Maintenance and CleaningLong periods of non usage Use only the specified cables Avoid placement in extreme temperaturesWhen the printer is being transported Do not disassemble or modify the printerSetupUnpacking ...........the printer 54-1 Introduction Key featuresCompliance Statement Setup Part Names Part Names cont’d Functions of various parts PowerCharging the battery pack with a charger Charging Time Charging the battery pack with the printer Using the battery pack InsertionRemoval Using the battery pack cont’d Using the optional AC Adapter for power Using the optional AC Adapter for power Installing the label roll Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Operation and Configuration Turning the printerTurning the printer OFF Performing a Test Print Printing via the RS-232C Interface Printing via the IrDA Interface Use the following procedure to print through IrDA interfaceCheck the DIP Switches Printing via the Wireless LAN InterfaceSynchronize Bluetooth settings Printing via the Bluetooth InterfaceOptional LCD screen OnlineOptional LCD screen cont’d Adjusting Display ContrastPrinting Procedure Adjusting printing for Non-separate labels Choosing the Label Dispensing mode Type Operation Configuring Dispense modeHead Check Setting and Online Command Setting Normal modeOther Printer Modes Printer modes cont’d Test Print ModeHead Check Setting Mode Setting Head Check Area cover must be left openOnline Command Compatibility Mode Setting Online Command compatibility Cover must be left openPosition Adjustments Offset Configuration via ProgrammingOperation and Configuration Other required settings Interface SpecificationsRS-232C settings Button held down Deactivate Head Check Interface Specifications Cleaning the Print Head Cleaning and MaintenanceCleaning the Platen and Peel Roller What to do in case TroubleshootingStatus Troubleshooting Troubleshooting Basic Specifications & Optional Accessories BasicOPTBASCSpecificationsIONALSPECIFICATINSACCESSORIESPaper thickness Interfaces Mini DIN RS-232C IrDA communication Complies Switches Environmental Measure to prevent interference e.g., installing partitions Battery Items Optional AccessoriesOptional Accessories Portability enhancements Pass one end Optional Accessories cont’d Portability enhancements Basic Specifications & Optional Accessories Factory-installed options Optional Accessories cont’d Connectivity options