SATO MB200/201i manual Optional LCD screen cont’d, Adjusting Display Contrast

Page 38

Operation and Configuration

Optional LCD screen (cont’d)

Two-line text display: Displays the following:

1)Various status messages: Firmware version, Online mode, Offline mode, labels remaining in print queue, Test Print status, Default Setting, Complete, Factory Clear, Press Feed Key, Press Print Key, Hex Dump Mode, Set up Display, Adjust LCD, Exit, Contrast, Back Light On

2)Warning messages: Cover Open, Paper End, Sensor Error, Buffer Near Full, Head Protect, Head Error, Module Error,

3)WLAN information: Messages such as Adhoc mode, Infrastructure mode, IP address, subnet mask, default gateway, Socket Port Number.

Adjusting Display Contrast

To adjust the contrast of the LCD, go into Maintenance mode. Use the FEED button to select options, and the PRINT button to confirm a selection.

Now select the “Adjust LCD” option and then the Contrast “option”. Values cycle between 30 and 63.

3-8

Image 38
Contents MB200/201i Operator’sDirectPrinterThermalManual Version SI-MB20xi-01rA-02-05-OM Safety Precautions IiiExplanation of hazard symbols ExampleLiquids Foreign MatterAbnormal Conditions DisassemblyBattery care Power Supply Precautions ViiLocation PowerViii Hazardous partsLong periods of non usage Replacing the Battery PackMaintenance and Cleaning Do not disassemble or modify the printer Avoid placement in extreme temperaturesWhen the printer is being transported Use only the specified cablesSetupUnpacking ...........the printer 54-1 Key features IntroductionCompliance Statement Setup Part Names Part Names cont’d Power Functions of various partsCharging the battery pack with a charger Charging Time Charging the battery pack with the printer Removal Using the battery packInsertion Using the battery pack cont’d Using the optional AC Adapter for power Using the optional AC Adapter for power Installing the label roll Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Turning the printer OFF Operation and ConfigurationTurning the printer Performing a Test Print Printing via the RS-232C Interface Use the following procedure to print through IrDA interface Printing via the IrDA InterfacePrinting via the Wireless LAN Interface Check the DIP SwitchesPrinting via the Bluetooth Interface Synchronize Bluetooth settingsOnline Optional LCD screenAdjusting Display Contrast Optional LCD screen cont’dPrinting Procedure Adjusting printing for Non-separate labels Choosing the Label Dispensing mode Configuring Dispense mode Type OperationOther Printer Modes Head Check Setting and Online Command SettingNormal mode Test Print Mode Printer modes cont’dSetting Head Check Area cover must be left open Head Check Setting ModeSetting Online Command compatibility Cover must be left open Online Command Compatibility ModeOffset Configuration via Programming Position AdjustmentsOperation and Configuration Interface Specifications Other required settingsRS-232C settings Button held down Deactivate Head Check Interface Specifications Cleaning and Maintenance Cleaning the Print HeadCleaning the Platen and Peel Roller Troubleshooting What to do in caseStatus Troubleshooting Troubleshooting BasicOPTBASCSpecificationsIONALSPECIFICATINSACCESSORIES Basic Specifications & Optional AccessoriesPaper thickness Interfaces Mini DIN RS-232C IrDA communication Complies Switches Environmental Measure to prevent interference e.g., installing partitions Optional Accessories Battery ItemsOptional Accessories Portability enhancements Pass one end Optional Accessories cont’d Portability enhancements Basic Specifications & Optional Accessories Optional Accessories cont’d Connectivity options Factory-installed options