SATO MB200/201i manual Configuring Dispense mode, Type Operation

Operation and Configuration

Configuring Dispense mode

Dispense Mode can be set to Auto Print or Manual

Print, as described below.

Type	Operation
Auto Print	Prints one label after receiving data and waits for peeling.
	After peeling a label, automatically prints next label.
Manual	Prints one label after receiving data and enters offline
Print (this	state. Pressing the PRINT key allows next label to be
is the	printed. After printing the specified number of labels, print-
default set-
	ing terminates. No printing occurs even when the PRINT
ting)
	key is pressed.

To switch between Auto or Manual Print for the Dispense Mode, set the DIP switches and then hold down the PRINT or FEED button when turning the printer ON. The new settings take effect when the printer is next turned ON.

Setting Auto Print dispense mode:

DSW1-4=OFF,OFF,OFF,ON + Cover open + Print button + power ON

Setting Manual Print dispense mode:

DSW1-4=OFF,OFF,OFF,ON + Cover open + FEED button + power ON

When setting the dispense mode, the STATUS LED blinks green, and turns into a steady green signal upon completion of setting. Turn off the printer ONLY when the STATUS LED is a steady green light.

3-12