SATO MB200/201i manual Adjusting printing for Non-separate labels

Page 40

Operation and Configuration

Adjusting printing for Non-separate labels

When printing on a continuous label roll (non- separate), if you tear off a label at the wrong place, proceed as follows.

1.Interrupt printing on the computer, or by pressing the PRINT key in the ONLINE state to take the printer OFFLINE. (STATUS LED goes off).

2.Press the FEED button to feed a label. When the feeding stops, tear off the label correctly by pulling the label in the direction of the arrow shown in the diagram. The label is now aligned properly for printing to resume.

3.Press the PRINT button to return to the online state (STATUS LED lights green). You can now resume the print job.

3-10

Image 40

Contents MB200/201i Operator’sDirectPrinterThermalManual Version SI-MB20xi-01rA-02-05-OM Safety Precautions IiiExplanation of hazard symbols ExampleLiquids Foreign MatterBattery care DisassemblyAbnormal Conditions Power Supply Precautions ViiPower ViiiLocation Hazardous partsMaintenance and Cleaning Replacing the Battery PackLong periods of non usage Avoid placement in extreme temperatures When the printer is being transportedDo not disassemble or modify the printer Use only the specified cablesSetupUnpacking ...........the printer 54-1 Key features IntroductionCompliance Statement Setup Part Names Part Names cont’d Power Functions of various partsCharging the battery pack with a charger Charging Time Charging the battery pack with the printer Insertion Using the battery packRemoval Using the battery pack cont’d Using the optional AC Adapter for power Using the optional AC Adapter for power Installing the label roll Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Turning the printer Operation and ConfigurationTurning the printer OFF Performing a Test Print Printing via the RS-232C Interface Use the following procedure to print through IrDA interface Printing via the IrDA InterfacePrinting via the Wireless LAN Interface Check the DIP SwitchesPrinting via the Bluetooth Interface Synchronize Bluetooth settingsOnline Optional LCD screenAdjusting Display Contrast Optional LCD screen cont’dPrinting Procedure Adjusting printing for Non-separate labels Choosing the Label Dispensing mode Configuring Dispense mode Type OperationNormal mode Head Check Setting and Online Command SettingOther Printer Modes Test Print Mode Printer modes cont’dSetting Head Check Area cover must be left open Head Check Setting ModeSetting Online Command compatibility Cover must be left open Online Command Compatibility ModeOffset Configuration via Programming Position AdjustmentsOperation and Configuration Interface Specifications Other required settingsRS-232C settings Button held down Deactivate Head Check Interface Specifications Cleaning and Maintenance Cleaning the Print HeadCleaning the Platen and Peel Roller Troubleshooting What to do in caseStatus Troubleshooting Troubleshooting BasicOPTBASCSpecificationsIONALSPECIFICATINSACCESSORIES Basic Specifications & Optional AccessoriesPaper thickness Interfaces Mini DIN RS-232C IrDA communication Complies Switches Environmental Measure to prevent interference e.g., installing partitions Optional Accessories Battery ItemsOptional Accessories Portability enhancements Pass one end Optional Accessories cont’d Portability enhancements Basic Specifications & Optional Accessories Optional Accessories cont’d Connectivity options Factory-installed options