SATO MB200/201i manual Liquids, Foreign Matter

Page 5

Warning

Warnings

Liquids

Do not place any liquids or small metallic objects near the printer. Should any of these fall into the printer, immediately turn off the power and contact your nearest dealer or service center. Continued use increases the risk of fire or electric shocks.

Foreign Matter

Do not insert or drop metallic or flammable objects into the openings of the printer (such as outlets for cables). If this happens, immediately turn off the power and contact your nearest dealer or service center. Continued use increases the risk of fire or electric shocks.

Foreign Matter

Should the printer be dropped or become damaged, immediately turn off the power and contact your nearest dealer or service center. Continued use increases the risk of fire or electric shocks.

v

Image 5

Contents MB200/201i Operator’sDirectPrinterThermalManual Version SI-MB20xi-01rA-02-05-OM Iii Safety PrecautionsExample Explanation of hazard symbolsForeign Matter LiquidsAbnormal Conditions DisassemblyBattery care Vii Power Supply PrecautionsViii PowerLocation Hazardous partsLong periods of non usage Replacing the Battery PackMaintenance and Cleaning When the printer is being transported Avoid placement in extreme temperaturesDo not disassemble or modify the printer Use only the specified cablesSetupUnpacking ...........the printer 54-1 Introduction Key featuresCompliance Statement Setup Part Names Part Names cont’d Functions of various parts PowerCharging the battery pack with a charger Charging Time Charging the battery pack with the printer Removal Using the battery packInsertion Using the battery pack cont’d Using the optional AC Adapter for power Using the optional AC Adapter for power Installing the label roll Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Turning the printer OFF Operation and ConfigurationTurning the printer Performing a Test Print Printing via the RS-232C Interface Printing via the IrDA Interface Use the following procedure to print through IrDA interfaceCheck the DIP Switches Printing via the Wireless LAN InterfaceSynchronize Bluetooth settings Printing via the Bluetooth InterfaceOptional LCD screen OnlineOptional LCD screen cont’d Adjusting Display ContrastPrinting Procedure Adjusting printing for Non-separate labels Choosing the Label Dispensing mode Type Operation Configuring Dispense modeOther Printer Modes Head Check Setting and Online Command SettingNormal mode Printer modes cont’d Test Print ModeHead Check Setting Mode Setting Head Check Area cover must be left openOnline Command Compatibility Mode Setting Online Command compatibility Cover must be left openPosition Adjustments Offset Configuration via ProgrammingOperation and Configuration Other required settings Interface SpecificationsRS-232C settings Button held down Deactivate Head Check Interface Specifications Cleaning the Print Head Cleaning and MaintenanceCleaning the Platen and Peel Roller What to do in case TroubleshootingStatus Troubleshooting Troubleshooting Basic Specifications & Optional Accessories BasicOPTBASCSpecificationsIONALSPECIFICATINSACCESSORIESPaper thickness Interfaces Mini DIN RS-232C IrDA communication Complies Switches Environmental Measure to prevent interference e.g., installing partitions Battery Items Optional AccessoriesOptional Accessories Portability enhancements Pass one end Optional Accessories cont’d Portability enhancements Basic Specifications & Optional Accessories Factory-installed options Optional Accessories cont’d Connectivity options