SATO MB200/201i manual Printing via the Bluetooth Interface, Synchronize Bluetooth settings

Page 36

Operation and Configuration

Printing via the Bluetooth Interface

To print using the Bluetooth-enabled version of MB200/201i, you need to have a bluetooth-enabled computing device. Two more steps are required.

1) Check the DIP Switches:

The printer’s DIP switches are factory set for bluetooth

operation. Check that Dip switch 1 is OFF and Dip switch 2 is ON. This is the main setting for Bluetooth operation. In case you need to reset other switches, refer to the full DIP-Switch table in the next chapter, Interface Specifications.

2) Synchronize Bluetooth settings

After setting the DIP-switches, the next step is to ensure that both bluetooth devices are configured to operate with the same PIN code and Authentication mode settings. Refer to the instruction manual of the computing device for details on how to set these parameters.

For the MB200/201i, these parameters can be set by

aSATO-certified System Integrator/dealer, or by using Bluetooth communication software available from your SATO dealer or service center.

Note

When printing with the Bluetooth interface, the usable range between the printer and the host may vary depending on the usage environment and the capabilities of the connected devices.

3-6

Image 36

Contents MB200/201i Operator’sDirectPrinterThermalManual Version SI-MB20xi-01rA-02-05-OM Safety Precautions IiiExplanation of hazard symbols ExampleLiquids Foreign MatterDisassembly Battery careAbnormal Conditions Power Supply Precautions ViiPower ViiiLocation Hazardous partsReplacing the Battery Pack Maintenance and CleaningLong periods of non usage Avoid placement in extreme temperatures When the printer is being transportedDo not disassemble or modify the printer Use only the specified cablesSetupUnpacking ...........the printer 54-1 Key features IntroductionCompliance Statement Setup Part Names Part Names cont’d Power Functions of various partsCharging the battery pack with a charger Charging Time Charging the battery pack with the printer Using the battery pack InsertionRemoval Using the battery pack cont’d Using the optional AC Adapter for power Using the optional AC Adapter for power Installing the label roll Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Installing the label roll cont’d Operation and Configuration Turning the printerTurning the printer OFF Performing a Test Print Printing via the RS-232C Interface Use the following procedure to print through IrDA interface Printing via the IrDA InterfacePrinting via the Wireless LAN Interface Check the DIP SwitchesPrinting via the Bluetooth Interface Synchronize Bluetooth settingsOnline Optional LCD screenAdjusting Display Contrast Optional LCD screen cont’dPrinting Procedure Adjusting printing for Non-separate labels Choosing the Label Dispensing mode Configuring Dispense mode Type OperationHead Check Setting and Online Command Setting Normal modeOther Printer Modes Test Print Mode Printer modes cont’dSetting Head Check Area cover must be left open Head Check Setting ModeSetting Online Command compatibility Cover must be left open Online Command Compatibility ModeOffset Configuration via Programming Position AdjustmentsOperation and Configuration Interface Specifications Other required settingsRS-232C settings Button held down Deactivate Head Check Interface Specifications Cleaning and Maintenance Cleaning the Print HeadCleaning the Platen and Peel Roller Troubleshooting What to do in caseStatus Troubleshooting Troubleshooting BasicOPTBASCSpecificationsIONALSPECIFICATINSACCESSORIES Basic Specifications & Optional AccessoriesPaper thickness Interfaces Mini DIN RS-232C IrDA communication Complies Switches Environmental Measure to prevent interference e.g., installing partitions Optional Accessories Battery ItemsOptional Accessories Portability enhancements Pass one end Optional Accessories cont’d Portability enhancements Basic Specifications & Optional Accessories Optional Accessories cont’d Connectivity options Factory-installed options