SATO CX200 manual Printer Setup Loading Ribbon

SECTION 1 - GENERAL INFORMATION

1-6 Printer Setup

Loading Ribbon (Continued)

10.Turn the take-up knob to pull the ribbon over the print head without any slack. Check to make sure there are no ribbon wrinkles.

11.Lower the print head and press it down firmly until it locks closed on both sides.

12.Close the top case.

13.Wait until the Ready Indicator glows green and press the FEED button to feed a label or to resume printing.

14.If the printer feeds out 7 inches of label and stops, and the indicator glows red, recalibrate for the media installed. See calibration.

SPINDLE

NOTCHES

BOTH ENDS

ROLL SEVERAL TURNS ON THE TAKE-UP CORE

PRESS BACK THE RELEASES TO UNLOCK

DIRECT THERMAL

UNIT SHOWN

(NO RIBBON)

UNWIND ABOUT 4"

SPINDLE

NOTCHES

BOTH ENDS

13

SATO SERVICE MANUAL

CX Series Printers

Rev B