SATO CX200 manual Head Open Switch Removal/Replacement, Switch removal, Switch installation

Page 47

46

3-10 Head Open Switch Removal/Replacement

REFER TO THE ACCOMPANYING ILLUSTRATIONS

Switch removal:

1.Remove the printer chassis according to the instructions in Section 3-4.

2.Insert a flat-bladed screwdriver under the switch body and gently pry it up to detach from the chassis protrusions.

3.Unplug the two connectors.

UNPLUG

CONNECTORS

	GENTLY PRY THE SWITCH	SCREWDRIVER
	BODY WITH A FLAT-BLADED
		BLADE
	SCREWDRIVER

Switch installation:

Reverse the above steps to install the switch.

Rev B

SATO SERVICE MANUAL

CX Series Printers

Image 47

Contents CX200 Overview SectionDimensions Environmental SpecificationsAttributes Attributes Device Name Primary Function USE Controls, Indicators and ConnectionsSerial Input Connector DB9S Printer Power Connection Connecting the Interface Cable Also Refer to the Accompanying Illustrations Next Printer Setup Loading Labels or TagsPrinter Setup Loading Labels or Tags Also Refer to the Accompanying Illustrations Printer Setup Loading RibbonPrinter Setup Loading Ribbon Printer Setup Loading Ribbon Selecting the Label Sensor Type Printer Test and Calibration Preparation for Test Installing the software to your hard driveDescription of Test Menu Running the software from your 3-1/2 drivePrinter Test and Calibration Print Head / Status Print Access the softwarePrinter Test and Calibration Change RS232 Settings Printer Test and Calibration Change RS232 Settings Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Calibrate Printer Sequence of events when the Calibration Program is run Basic Operations Printing and Reading a Self-test Label Example Self Test Label Sending Data to the Printer Printer Ready/Standby/Reset ControlBasic Operations Feeding Blank Labels Label ReprintPrinting Labels Basic Operations Printer Ready/Standby/Reset ControlControlling the Printer Using Direct Commands Cleaning MaintenanceCleaning Clean Platen Rollerlabel Feed Direction Rev Preparing the Printer for Service Parts ReplacementSection Description KIT Part Number Replaceable PartsReplaceable Parts Replaceable Parts Location Refer to the Illustration Top Case Removal/ReplacementTo remove the chassis Chassis, Including the Front Case Removal/ReplacementTo replace the chassis and front case Chassis, Including Front Case Removal/ReplacementPlaten removal Platen Removal/ReplacementPlaten installation Print head removal Print Head Removal/ReplacementPrint head installation Module removal Pcba Module Removal/ReplacementModule replacement PCA board removal PCA Base Board Removal/ReplacementPCA board installation Motor removal Motor Removal/ReplacementMotor installation Switch installation Head Open Switch Removal/ReplacementSwitch removal Cluster gear removal Cluster Gear Removal/ReplacementCluster gear installation CX Series Printers Preliminary Tests TroubleshootingReady light is not lit Common Problems and Their SolutionsHost stops responding or displays printer not ready message Printer feeds too many labels Ribbon wrinkles Printed labels are cut off at the bottom

Related manuals

Manual 24 pages 583 b