SATO CX200 manual Example Self Test Label

Page 27

26

1-8 Basic Operations

Printing and Reading a Self-test Label

Firmware Revision

Serial Number

RS232 Setting

Current Printer Heat Setting

Total Number of Inches Printed

Print Speed

Current Calibration Setting

Print Mode (DT= Direct Thermal )

(TT= Thermal Transfer)

Label Forward/Backfeed

Protocol Codes

(Factory Use Only)

Expanded Memory Installed

Pitch Offset

Hex Dump Mode

Hex Dump Code

EXAMPLE:

SELF TEST LABEL

When sending data in normal operation and nothing prints, put the printer in the Hex mode and try resending the data. The printer should print out the hex characters corresponding to the data received. If nothing prints, check cabling and media. If you get a hex dump, compare it to the command stream you are sending. If it is the same, the command sent could be wrong. Refer to the Programming Guide for information on programming the printer and the correct use of the printer commands.

Rev B

SATO SERVICE MANUAL

CX Series Printers

Image 27

Contents CX200 Overview SectionDimensions Environmental SpecificationsAttributes Attributes Device Name Primary Function USE Controls, Indicators and ConnectionsSerial Input Connector DB9S Printer Power Connection Connecting the Interface Cable Also Refer to the Accompanying Illustrations Next Printer Setup Loading Labels or TagsPrinter Setup Loading Labels or Tags Also Refer to the Accompanying Illustrations Printer Setup Loading RibbonPrinter Setup Loading Ribbon Printer Setup Loading Ribbon Selecting the Label Sensor Type Printer Test and Calibration Preparation for Test Installing the software to your hard driveDescription of Test Menu Running the software from your 3-1/2 drivePrinter Test and Calibration Print Head / Status Print Access the softwarePrinter Test and Calibration Change RS232 Settings Printer Test and Calibration Change RS232 Settings Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Calibrate Printer Sequence of events when the Calibration Program is run Basic Operations Printing and Reading a Self-test Label Example Self Test Label Sending Data to the Printer Printer Ready/Standby/Reset ControlBasic Operations Feeding Blank Labels Label ReprintBasic Operations Printer Ready/Standby/Reset Control Controlling the Printer Using Direct CommandsPrinting Labels Cleaning MaintenanceCleaning Clean Platen Rollerlabel Feed Direction Rev Preparing the Printer for Service Parts ReplacementSection Description KIT Part Number Replaceable PartsReplaceable Parts Replaceable Parts Location Refer to the Illustration Top Case Removal/ReplacementTo remove the chassis Chassis, Including the Front Case Removal/ReplacementTo replace the chassis and front case Chassis, Including Front Case Removal/ReplacementPlaten Removal/Replacement Platen installationPlaten removal Print head removal Print Head Removal/ReplacementPrint head installation Pcba Module Removal/Replacement Module replacementModule removal PCA Base Board Removal/Replacement PCA board installationPCA board removal Motor Removal/Replacement Motor installationMotor removal Head Open Switch Removal/Replacement Switch removalSwitch installation Cluster Gear Removal/Replacement Cluster gear installationCluster gear removal CX Series Printers Preliminary Tests TroubleshootingReady light is not lit Common Problems and Their SolutionsHost stops responding or displays printer not ready message Printer feeds too many labels Ribbon wrinkles Printed labels are cut off at the bottom

Related manuals

Manual 24 pages 583 b