SATO CX200 manual Chassis, Including the Front Case Removal/Replacement, To remove the chassis

Page 39

3-4 Chassis, Including the Front Case Removal/Replacement

The chassis must be removed to access and remove other components that are fastened to the chassis body. The front case is set in slots in the bottom case and both are removed from the chassis as a unit. The chassis is held in the printer case by two tabs, which can reached through two access slots in the bottom of the printer. To simplify the process of removing the chassis from the printer, follow these instructions closely.

REFER TO THE ACCOMPANYING ILLUSTRATIONS

To remove the chassis:

Insert a flat-bladed screwdriver into each of the two chassis release slots between the tabs and case and push the screwdriver in the direction shown. For the right side slot, insert the screwdriver and push toward the front of the printer. For the left side slot, insert the screwdriver and push toward the rear of the printer while pulling the chassis away from the printer case. The front case will come out with the chassis. Lift the front case from the chassis.

38

INSERT SCREWDRIVER INTO EACH SLOT, PUSH UP ON THE RIGHT SIDE, PUSH DOWN ON THE LEFT SIDE

PUSH DOWN

TO THE REAR

PUSH UP TO

THE FRONT

CASE

TAB

INSERT SCREWDRIVER

BETWEEN TAB AND CASE

RIGHT

SIDE TAB

LEFT

SIDE TAB

Rev B

SATO SERVICE MANUAL

CX Series Printers

Image 39
Contents CX200 Overview SectionDimensions Environmental SpecificationsAttributes Attributes Device Name Primary Function USE Controls, Indicators and ConnectionsSerial Input Connector DB9S Printer Power Connection Connecting the Interface Cable Also Refer to the Accompanying Illustrations Next Printer Setup Loading Labels or TagsPrinter Setup Loading Labels or Tags Also Refer to the Accompanying Illustrations Printer Setup Loading RibbonPrinter Setup Loading Ribbon Printer Setup Loading Ribbon Selecting the Label Sensor Type Printer Test and Calibration Preparation for Test Installing the software to your hard driveDescription of Test Menu Running the software from your 3-1/2 drivePrinter Test and Calibration Print Head / Status Print Access the softwarePrinter Test and Calibration Change RS232 Settings Printer Test and Calibration Change RS232 Settings Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Calibrate Printer Sequence of events when the Calibration Program is run Basic Operations Printing and Reading a Self-test Label Example Self Test Label Sending Data to the Printer Printer Ready/Standby/Reset ControlBasic Operations Feeding Blank Labels Label ReprintBasic Operations Printer Ready/Standby/Reset Control Controlling the Printer Using Direct CommandsPrinting Labels Cleaning MaintenanceCleaning Clean Platen Rollerlabel Feed Direction Rev Preparing the Printer for Service Parts ReplacementSection Description KIT Part Number Replaceable PartsReplaceable Parts Replaceable Parts Location Refer to the Illustration Top Case Removal/ReplacementTo remove the chassis Chassis, Including the Front Case Removal/ReplacementTo replace the chassis and front case Chassis, Including Front Case Removal/ReplacementPlaten Removal/Replacement Platen installationPlaten removal Print head removal Print Head Removal/ReplacementPrint head installation Pcba Module Removal/Replacement Module replacementModule removal PCA Base Board Removal/Replacement PCA board installationPCA board removal Motor Removal/Replacement Motor installationMotor removal Head Open Switch Removal/Replacement Switch removalSwitch installation Cluster Gear Removal/Replacement Cluster gear installationCluster gear removal CX Series Printers Preliminary Tests TroubleshootingReady light is not lit Common Problems and Their SolutionsHost stops responding or displays printer not ready message Printer feeds too many labels Ribbon wrinkles Printed labels are cut off at the bottom
Related manuals
Manual 24 pages 583 b