SATO CX200 manual Motor Removal/Replacement, Motor removal, Motor installation

3-9 Motor Removal/Replacement

REFER TO THE ACCOMPANYING ILLUSTRATIONS

Motor removal:

1.Remove the printer chassis according to the instructions in Section 3-4.

2.Remove the two Phillips-head screws holding the PCA base board in place.

3.Lift the PCA base board gently, then unplug the feed switch connector at J13

4.Unplug the motor wiring at connector J10

5.Remove the Phillips-head screw holding the motor in place.

6.Turn the motor body until the motor flanges clear the printer chassis, then remove the motor.

UNPLUG THE

CONNECTOR

AT J10

REMOVE PHILLIPS-

HEAD SCREW AND

LIFT THE MOTOR

Motor installation:

Reverse the above steps to install the motor.

45

SATO SERVICE MANUAL

CX Series Printers

Rev B