SATO CX200 manual Printer Power Connection

Page 9

SECTION 1 - GENERAL INFORMATION

1-5 Controls, Indicators and Connections

Printer Power Connection

1.Plug the output of the AC power supply provided with the printer into the connector on the underside of the printer.

2.Plug the supply into an AC outlet having the correct voltage.

Important!

The required AC voltage is marked on the power supply. Confirm that your AC voltage matches the power supply requirements. Do not use any power supply other then the one provided with the printer.

Note:

CX200 printers consume very little power when idle so are not equipped with a power switch. Press the READY indicator/ON-OFF (a combined control) to reset the printer and switch from OFF-Line to On-Line mode.

UNDERSIDE OF PRINTER

POWER INPUT

READY INDICATOR

ON-LINE/OFF LINE

BUTTON

POWER

SUPPLY

AC OUTLET

8

FEED BUTTON

Rev B

SATO SERVICE MANUAL

CX Series Printers

Image 9

Contents CX200 Overview SectionDimensions Environmental SpecificationsAttributes Attributes Device Name Primary Function USE Controls, Indicators and ConnectionsSerial Input Connector DB9S Printer Power Connection Connecting the Interface Cable Also Refer to the Accompanying Illustrations Next Printer Setup Loading Labels or TagsPrinter Setup Loading Labels or Tags Also Refer to the Accompanying Illustrations Printer Setup Loading RibbonPrinter Setup Loading Ribbon Printer Setup Loading Ribbon Selecting the Label Sensor Type Printer Test and Calibration Preparation for Test Installing the software to your hard driveDescription of Test Menu Running the software from your 3-1/2 drivePrinter Test and Calibration Print Head / Status Print Access the softwarePrinter Test and Calibration Change RS232 Settings Printer Test and Calibration Change RS232 Settings Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Set Top of Form Pitch Offset Printer Test and Calibration Calibrate Printer Sequence of events when the Calibration Program is run Basic Operations Printing and Reading a Self-test Label Example Self Test Label Basic Operations Feeding Blank Labels Printer Ready/Standby/Reset ControlLabel Reprint Sending Data to the PrinterBasic Operations Printer Ready/Standby/Reset Control Controlling the Printer Using Direct CommandsPrinting Labels Cleaning MaintenanceCleaning Clean Platen Rollerlabel Feed Direction Rev Preparing the Printer for Service Parts ReplacementSection Description KIT Part Number Replaceable PartsReplaceable Parts Replaceable Parts Location Refer to the Illustration Top Case Removal/ReplacementTo remove the chassis Chassis, Including the Front Case Removal/ReplacementTo replace the chassis and front case Chassis, Including Front Case Removal/ReplacementPlaten Removal/Replacement Platen installationPlaten removal Print head removal Print Head Removal/ReplacementPrint head installation Pcba Module Removal/Replacement Module replacementModule removal PCA Base Board Removal/Replacement PCA board installationPCA board removal Motor Removal/Replacement Motor installationMotor removal Head Open Switch Removal/Replacement Switch removalSwitch installation Cluster Gear Removal/Replacement Cluster gear installationCluster gear removal CX Series Printers Preliminary Tests TroubleshootingReady light is not lit Common Problems and Their SolutionsHost stops responding or displays printer not ready message Printer feeds too many labels Ribbon wrinkles Printed labels are cut off at the bottom

Related manuals

Manual 24 pages 583 b