SATO CX200 manual Print Head Removal/Replacement, Print head removal

3-6 Print Head Removal/Replacement

REFER TO THE ACCOMPANYING ILLUSTRATIONS

Print head removal:

1.Raise the top case.

2.Press the two print head release latches back to release the print head, then lift the print head until it is fully raised and latched in the open position.

3.Press the print head down with your thumbs (towards the printer chassis) and slide the front edges away from the slots on the printer frame.

4.Pull the print head away from the printer frame and rotate towards you so that the springs are facing your direction.

5.Unplug the print head ground lead from its push-on connector on the print head. Unplug the sensor LED connector.

NOTE:

The sensor LED is polarity-sensitive; observe the orientation of the LED connector when disconnecting and reconnecting it. The red lead should be closest to the print head.

6. Unplug the print head connector.	PRESS PRINT HEAD DOWN AND
	SLIDE FRONT EDGES AWAY
	FROM THE SLOTS

PRINT HEAD

PRESS BACK THE

RELEASES TO UNLOCK

41

SATO SERVICE MANUAL

CX Series Printers

Rev B