TRENDnet TPL310AP manual Led

LED	Color	Sequen	Definition
		ce
PWR (Power)	Green	Solid	Device powered On
	N/A	Off	Device powered Off
		Solid	Powerline Connected (Connection Quality is Best)
PL (Powerline)	Green
		Blinking	Syncing or Powerline Data Transmitting/Receiving (Connection Quality is
			Best)
Note: LED color	Amber	Solid	Powerline Connected (Connection Quality is Better)
indicates the strength
		Blinking	Powerline Data Transmitting/Receiving (Connection Quality is Better)
and quality of the
powerline connection	Red	Solid	Powerline Connected (Connection Quality is Good)
through the electrical
		Blinking	Powerline Data Transmitting/Receiving (Connection Quality is Good)
system
	N/A	Off	Powerline is not synced or connected
		Solid	10/20 Mbps, 100/200Mbps, or 1000/2000Mbps (Half/Full
			Duplex) Connected
	Green
ETH
		Blinking	10/20Mbps, 100/200Mbps, or 1000/2000Mbps (Half/Full Duplex) Data
(Ethernet Port)
			Transmitting/Receiving
	N/A	Off	Port Disconnected/No Ethernet Link
WIFI	Green	Blinking	Wireless is on or enabled / Wireless Data Transmission
(Wireless)
	N/A	Off	Wireless is off or disabled
WPS	Green	Blinking	WPS is activated
(WiFi Protected Setup)
	N/A	Off	WPS is not activated or disabled

*Note: The following factors may affect the powerline network’s connection quality:

∙Noise – Generated by appliances that are connected to your electrical system through power outlets that have high power consumption requirements. (e.g. Microwaves, ovens, blow dryer, iron, dishwasher, etc.) The quality of your household electrical wiring may also cause additional noise on your electrical system.

∙Distance – Long lengths of electrical wiring through your electrical system between connected powerline adapters.

Button	Action	Function
		Initiate Sync/Connection and generate random network name/key on first
		adapter (PWR LED will start blinking)
		Match network name/key on secondary or additional adapter and connect to
Sync	Push/Hold for 2 sec	first adapter. (PWR LED will start blinking)
		Note: The secondary or additional powerline adapter’s Sync button must also
		be pushed within 2 minutes (120 sec) of pushing the Sync button of the first
		adapter in order to establish connectivity.
	Push/Hold for 10 sec	Erases the network name/key (All LEDs will turn off and turn back on)
WPS	Push/Hold for 3 sec	Activates Wi-Fi Protected Setup (WPS)
		Reset to Powerline factory defaults only (All LEDs will turn off and turn back on,
		PL LED will blink Amber)
	Push/Hold for 1 sec	Note: Will reset to the factory default private network name “HomePlugAV”.
Reset		This will not reset Wireless Access Point settings and the settings will remain
		intact.
		Reset to Wireless Access Point factory defaults only (All LEDs will turn off and
	Push/Hold for 5 sec	turn back on)
		Note: This will not reset Powerline settings and the settings will remain intact.