TRENDnet TPL310AP manual Using the Utility, Upgrade Firmware

Page 50

5.2 Using the Utility

Double-click the desktop icon to open the Powerline Configuration Utility application.

Local Device

The closest powerline adapter(s) that connects your computer to the electrical system.

Remote Devices

Privacy Tab

Change the Network Name/Security Key

Upgrade Firmware

Upgrade the firmware of the Local Device

Powerline adapters that are connected to the selected Local Device across the electrical system.

Rename the

Enter the

selected

Device

Add a

Remote

Scans for

Remote

Closes the

utility

application.

Remote

Password

Device

(DPW) for the

 

selected

 

Remote Device

Device that

was not

detected

Devices that

were not detected

To apply changes to Remote Devices through the Powerline Configuration Utility, you must enter the Device Password (DPW) for each Remote Device located on the Device Label.

If you have not already done so, please write down the 16-digit Device Password (DPW) and corresponding MAC Address of each TRENDnet HomePlug® AV powerline adapter as this will be used to input into the utility. This is located on the Device Label, please refer to Section 1.3.

Enter the 16-digit Device Password (DPW) for each Remote Device in the utility

1.Click one of the Remote Devices in the list.

2.Click Enter Password.

3.Type in the Device Password according to the corresponding MAC address. Then click OK.

Image 50
Contents Page Safety RoHS Table of Contents Overlapping Powerline Networks Product Overview Expanding a Wired Network Expanding an Existing Powerline NetworkExpanding a Wireless Network Wireless Technical FeaturesPowerline Memory Package ContentsSystem Requirements Device Label LEDs & ButtonsLED Top Panel Defaults SettingsWireless AP Setting IP Address / Subnet Mask 192.168.10.100 TRENDnet310Wireless Access Point Initial Setup Page Page Page Page Page Wireless AP Setting Wireless Access Point Web Management InterfaceDefault Configuration Settings Menu ItemsStatus Wireless Apply/Reset Changes Basic SettingsNetwork Type AP+WDS Access Point + Wireless Distribution System AllowsDescription of Modes Control SidebandMultiple Ssid Active Wireless Client Table Advanced SettingsSecurity 802.1x Authentication WEP SecurityWPA/WPA2 Security Pre-Shared Key Format WPA MixedWPA / WPA2 Cipher Suite Current Access Control Access ControlWireless Access Control CommentCurrent WDS AP List WDS SettingsItems Information MAC Address Mesh Settings Items Information Mesh IDSite Survey 11 WPS Days Sun, Mon, Tue, Wed, Thu, Fri, Sat Check Items Information Enable Wireless ScheduleSchedule Time802.1d Spanning Tree TCP/IP SettingsItems Information IP Address Clone MAC AddressLog Enable LogEnable Remote Log Types of LoggingStatistics Upgrade FirmwareSave/Reload Settings Logout PasswordSystem Time Powerline Create a powerline network and extend you wireless network Page Securing your Powerline Network Changing the Network Name/Security Key using the Sync ButtonPage Overlapping Powerline Networks Page Powerline Configuration Utility Software InstallationPage Page Confirm Installation window, click Next Using the Utility Upgrade FirmwarePage Troubleshooting PowerlineWireless Installation Considerations Specifications Frequency Band Access Point ModesOutput Power AntennaLimited Warranty PWP05202009v2