TRENDnet TPL310AP manual Active Wireless Client Table, Advanced Settings

Page 24

3.4.4 Active Wireless Client Table

This is the window that pops up after clicking the button. This will display information on wireless currently connected to each SSID including the primary.

3.4.5 Advanced Settings

You can set advanced wireless LAN parameters of this AP.

Note: The settings on this page are intended for more advanced users who have sufficient knowledge of wireless LAN technology. Please do not modify these settings unless you are well aware of the effects on the wireless access point functionality and performance as a result of these changes.

	Items	Information

		This value should remain at its default setting of 2346. If you
		experience a high packet error rate, you may slightly increase your
	Fragment Threshold	fragmentation threshold within the value range of 256 to 2346.
		Setting the fragmentation threshold too low may result in poor
		performance.

		Request To Send threshold. This value should remain at its default
	RTS Threshold	setting of 2347. If you encounter inconsistent data flow, only minor
	RTS Threshold	modifications to the value range between 0 and 2347 are
		modifications to the value range between 0 and 2347 are
		recommended.

	Beacon Interval	Beacons are packets sent by an access point to synchronize a

Image 24

Contents Page Safety RoHS Table of Contents Overlapping Powerline Networks Product Overview Expanding an Existing Powerline Network Expanding a Wireless NetworkExpanding a Wired Network Technical Features PowerlineWireless Package Contents System RequirementsMemory Device Label LEDs & ButtonsLED Defaults Settings Wireless AP Setting IP Address / Subnet Mask 192.168.10.100Top Panel TRENDnet310Wireless Access Point Initial Setup Page Page Page Page Page Wireless Access Point Web Management Interface Default Configuration SettingsWireless AP Setting Menu ItemsStatus Wireless Apply/Reset Changes Basic SettingsAP+WDS Access Point + Wireless Distribution System Allows Description of ModesNetwork Type Control SidebandMultiple Ssid Active Wireless Client Table Advanced SettingsSecurity 802.1x Authentication WEP SecurityWPA/WPA2 Security WPA Mixed WPA / WPA2 Cipher SuitePre-Shared Key Format Access Control Wireless Access ControlCurrent Access Control CommentWDS Settings Items Information MAC AddressCurrent WDS AP List Mesh Settings Items Information Mesh IDSite Survey 11 WPS Items Information Enable Wireless Schedule ScheduleDays Sun, Mon, Tue, Wed, Thu, Fri, Sat Check TimeTCP/IP Settings Items Information IP Address802.1d Spanning Tree Clone MAC AddressEnable Log Enable Remote LogLog Types of LoggingUpgrade Firmware Save/Reload SettingsStatistics Password System TimeLogout Powerline Create a powerline network and extend you wireless network Page Securing your Powerline Network Changing the Network Name/Security Key using the Sync ButtonPage Overlapping Powerline Networks Page Powerline Configuration Utility Software InstallationPage Page Confirm Installation window, click Next Using the Utility Upgrade FirmwarePage Troubleshooting PowerlineWireless Installation Considerations Specifications Access Point Modes Output PowerFrequency Band AntennaLimited Warranty PWP05202009v2