Xantrex Technology PH1800 manual Inverter Features, 2PowerHub 1800 Features

Page 22

Introduction

Inverter Features

User Features	The inverter consists of the following user features.
	• The Inverter Control Panel provides a user interface for monitoring
	power levels, battery levels, and controlling the inverter functions and
	displays.
	• Four 120 Vac outlets on the front panel provide up to 1440 W
	(continuous) output power.
	• One 15 A supplemental protector provides over-load protection to the
	four AC outlets on the front panel.
	• One AC Indicator LED. This LED will illuminate whenever AC
	power is available, whether the unit is ON or OFF. See page 2–3 for
	additional information about this LED.
	• One PVGFP, ground fault protection fuse for safety when using solar
	and wind renewable energy inputs.

WARNING: Shock Hazard

The 15 A circuit breaker on the front panel is only connected to the four outlets on the front of the panel and only disconnects power to these outlets when activated. It does not disable output through the output terminals used for hardwiring. Therefore, power can still be available to loads connected through a hardwired installation.

Inverter Control

Panel

ON/OFF Power

Button

AC Outlets (x4)

AC Indicator LED

15 A Supplemental

Protector

Figure 1-2PowerHub 1800 Features

1–4	975-0288-01-01

Image 22

Contents PowerHub Page PowerHub Operator’s GuideDate and Revision Scope About This GuidePurpose AudienceAbbreviations and Acronyms Conventions UsedRelated Information Important Safety Instructions Figure i Basic Safety Precautions When Working With Batteries Precautions for Using Rechargeable Appliances FCC/ICES 003 Information to the UserPower Down Procedure To Power Down the PowerHubIf hardwired...... To Power Down the PowerHub Contents Troubleshooting SpecificationsFigures Xiv Tables Page Introduction For this topic SeeIntroduction Principles of Inverter OperationBasic Functions of the PowerHub Primary AC sourceInverter Features 2PowerHub 1800 FeaturesBattery Charger Features Three-Stage Charging Process onVoltage 12.5 Vdc Contains information on operating the PowerHub Operation8.8 Inverter Control PanelUser Controls and Display LEDOperating Mode LEDs Status LEDsSelecting Charger Settings AC LEDPower On and Off Basic OperationChanging the Display 3Input Displays4Output Displays Changing Charging Settings AC is not availableConnecting AC Loads 6Connecting AC Loads Loads That Might Not Work Well With the PowerHub Typical Loads that might be used with the PowerHubLoads that should not be used with the PowerHub Troubleshooting How to Troubleshoot the PowerHub Error Codes Troubleshooting Error Codes for Troubleshooting the PowerHub If Utility Power is not Available 2Possible Problems if Utility Power is Not AvailableError code E02 If Utility Power is Available 3Possible Problems if Utility Power is AvailablePossible Problem Loads Rechargeable Devices Ground Fault Protection Replacing the Ground Fault Protection Fuse1Replacing Ground Fault Protection Fuse Page Specifications Electrical Specifications Table A-1Electrical Specifications for the InverterPhysical Specifications Battery Charger SpecificationsFigure A-1Three-Stage Charging Process Charging Profiles Amp Charging ProfileTable A-610-amp Charging Profile Index IX-2 975-0288-01-01 Warranty and Return Information WarrantyDisclaimer ProductReturn Procedure Return Material Authorization PolicyExclusions Out of Warranty Service Information About Your System Purchased From Purchase DateWA-6 Page Xantrex Technology Inc