Xantrex Technology PH1800 manual Changing Charging Settings, AC is not available

Page 33

Basic Operation

Changing Charging Settings

Default Setting	The PowerHub 1800 is set at the factory to default to the 40 A Charging
	Profile. In the event that one of the other profiles are required, follow the
	instructions below to change the setting.
Setting the	To set the selection to the desired profile, stop pressing the Select Button
Selection	when the desired profile is displayed. The unit will set the profile shown
	in the display, then will return to the default screen within 10 seconds.
Returns to	The charging setting will revert to the 40 A default setting whenever the
Default	ON/OFF Button is pressed or all DC input sources are removed and utility
	AC is not available.

Press and hold for approximately	Display shows default
3-5 seconds.	charge setting (40A)
The AC LED will start to flash.

Press again within 10 seconds.	The Charge Setting changes
	to the 10 A profile.

The Charge Setting changes to the

Press again within 10 seconds. 0 A profile. This profile completely turns off the charging feature.

Figure 2-5Input Displays

975-0288-01-01

2–9

Image 33

Contents PowerHub Page Operator’s Guide PowerHubDate and Revision Purpose About This GuideScope AudienceConventions Used Abbreviations and AcronymsRelated Information Important Safety Instructions Figure i Basic Safety Precautions When Working With Batteries FCC/ICES 003 Information to the User Precautions for Using Rechargeable AppliancesTo Power Down the PowerHub Power Down ProcedureIf hardwired...... To Power Down the PowerHub Contents Specifications TroubleshootingFigures Xiv Tables Page For this topic See IntroductionPrinciples of Inverter Operation IntroductionPrimary AC source Basic Functions of the PowerHub2PowerHub 1800 Features Inverter FeaturesThree-Stage Charging Process on Battery Charger FeaturesVoltage 12.5 Vdc Operation Contains information on operating the PowerHubInverter Control Panel 8.8LED User Controls and DisplayStatus LEDs Operating Mode LEDsAC LED Selecting Charger SettingsBasic Operation Power On and Off3Input Displays Changing the Display4Output Displays AC is not available Changing Charging SettingsConnecting AC Loads 6Connecting AC Loads Typical Loads that might be used with the PowerHub Loads That Might Not Work Well With the PowerHubLoads that should not be used with the PowerHub Troubleshooting How to Troubleshoot the PowerHub Error Codes Troubleshooting Error Codes for Troubleshooting the PowerHub 2Possible Problems if Utility Power is Not Available If Utility Power is not AvailableError code E02 3Possible Problems if Utility Power is Available If Utility Power is AvailablePossible Problem Loads Rechargeable Devices Replacing the Ground Fault Protection Fuse Ground Fault Protection1Replacing Ground Fault Protection Fuse Page Specifications Table A-1Electrical Specifications for the Inverter Electrical SpecificationsBattery Charger Specifications Physical SpecificationsFigure A-1Three-Stage Charging Process Amp Charging Profile Charging ProfilesTable A-610-amp Charging Profile Index IX-2 975-0288-01-01 Warranty Warranty and Return InformationProduct DisclaimerReturn Material Authorization Policy Return ProcedureExclusions Out of Warranty Service Purchased From Purchase Date Information About Your SystemWA-6 Page Xantrex Technology Inc