Selecting Charger Settings, Ac Led | Xantrex Technology PH1800

Xantrex Technology PH1800 manual Selecting Charger Settings, Ac Led

	Inverter Control Panel

Solar LED	When the Select Button is pressed again within 10 seconds and the Solar
	LED is illuminated, the Solar Input wattage levels are displayed in
	kilowatts. These values are the inputs on the 32 A DC input terminals.
AC LED	If the unit is in Bypass Mode, when the Select Button is pressed again
	within 10 seconds and the AC LED is illuminated, the battery charger
	power level is displayed in kilowatts.

Net Power LED	By default the Net Power LED represents the difference between the
	input and the output power levels. This value is shown on startup and will
	return to this display if the Select button is not pressed for 10 seconds.
	When using the Select Button to cycle through the displays and the Net
	Power LED is illuminated, the power level displayed will depend on
	whether the unit is in Bypass Mode or Inverter Mode.
	In Bypass Mode, the value displayed represents the power, in kilowatts,
	that is available to charge the battery and to power the loads. This will be
	a positive number.
	In Inverter Mode, this value displayed represents the total amount of
	power in kilowatts that is being drawn from the battery bank (negative
	numbers) or is available to charge the battery by the DC source while the
	inverter is running (positive numbers).
Battery LED	When the Select Button is pressed again within 10 seconds and the
	Battery Level LED is illuminated, the battery voltage level is displayed in
	DC volts. It will also show “FUL” when the battery is charged through the
	AC charger and reaches float and standby mode.
Output LED	When the Select Button is pressed again within 10 seconds and the
	Inverter LED is illuminated, the Inverter Output power is displayed in
	kilowatts. This only displays if the unit is in Invert Mode.

Selecting Charger Settings

Charger	Pressing and holding the Select Button for 3-5 seconds will change the
Settings	display to show the AC charger current setting and the AC LED will
	flash.
	See “Battery Charger Features” on page 1–5 for more information
	regarding setting parameters. See “Changing Charging Settings” on
	page 2–9 for instructions on changing this setting.

975-0288-01-01

2–5