Xantrex Technology Xantrex Error Codes and Inverter Fault Codes for PowerHub 1800

Ad

Page 40

Troubleshooting

Table 3-1	Error Codes for Troubleshooting the PowerHub 1800
Error Code		Description
Error Code		Description
Displayed		of Error	Description of Condition		Resolution

E06		AC Output	System is still operating but AC load		Unit continues to run.
		Overload	applied to the system in inverter mode is		If the warning is ignored, the
		Warning	close to shutdown limit.		unit will eventually go to the
			Alarm will beep once every two seconds		E03 fault condition.
			Alarm will beep once every two seconds
			until the warning condition is removed.

E07		System Over	System is still operating but system		Unit continues to run.
		Temperature	internal temperature is close to shutdown		If the warning is ignored, unit
		Warning	limit.		will eventually go to the E04
			Alarm will beep once every two seconds		fault condition.
			Alarm will beep once every two seconds
			until the warning condition is removed.

E09		Ground Fault	Unit shuts down.		Turn the unit off. Check all DC
		Fuse Open	A ground fault has been detection.		Input connections (PV, wind
		Warning	A ground fault has been detection.		etc.) and repair any faults or
		Warning			etc.) and repair any faults or
					damage. Replace the ground
					fault fuse (see page 3–10) and
					restart the unit

3–4	975-0288-01-01

Image 40

Contents PowerHub Page PowerHub Operator’s GuideDate and Revision About This Guide PurposeScope AudienceAbbreviations and Acronyms Conventions UsedRelated Information Important Safety Instructions Figure i Basic Safety Precautions When Working With Batteries Precautions for Using Rechargeable Appliances FCC/ICES 003 Information to the UserPower Down Procedure To Power Down the PowerHubIf hardwired...... To Power Down the PowerHub Contents Troubleshooting SpecificationsFigures Xiv Tables Page Introduction For this topic SeeIntroduction Principles of Inverter OperationBasic Functions of the PowerHub Primary AC sourceInverter Features 2PowerHub 1800 FeaturesBattery Charger Features Three-Stage Charging Process onVoltage 12.5 Vdc Contains information on operating the PowerHub Operation8.8 Inverter Control PanelUser Controls and Display LEDOperating Mode LEDs Status LEDsSelecting Charger Settings AC LEDPower On and Off Basic OperationChanging the Display 3Input Displays4Output Displays Changing Charging Settings AC is not availableConnecting AC Loads 6Connecting AC Loads Loads That Might Not Work Well With the PowerHub Typical Loads that might be used with the PowerHubLoads that should not be used with the PowerHub Troubleshooting How to Troubleshoot the PowerHub Error Codes Troubleshooting Error Codes for Troubleshooting the PowerHub If Utility Power is not Available 2Possible Problems if Utility Power is Not AvailableError code E02 If Utility Power is Available 3Possible Problems if Utility Power is AvailablePossible Problem Loads Rechargeable Devices Ground Fault Protection Replacing the Ground Fault Protection Fuse1Replacing Ground Fault Protection Fuse Page Specifications Electrical Specifications Table A-1Electrical Specifications for the InverterPhysical Specifications Battery Charger SpecificationsFigure A-1Three-Stage Charging Process Charging Profiles Amp Charging ProfileTable A-610-amp Charging Profile Index IX-2 975-0288-01-01 Warranty and Return Information WarrantyDisclaimer ProductReturn Procedure Return Material Authorization PolicyExclusions Out of Warranty Service Information About Your System Purchased From Purchase DateWA-6 Page Xantrex Technology Inc